1 / 15

AdLIGO Optical configuration and control Nov 10, 2005 Alan Weinstein

AdLIGO Optical configuration and control Nov 10, 2005 Alan Weinstein for AdLIGO Interferometer Sensing and Control (ISC) and the 40 meter lab. 40 KG FUSED SILICA. ADVANCED LIGO LAYOUT. BS Beam Splitter ITM Input Test Mass ETM End Test Mass PD Photodiode

aseaman
Télécharger la présentation

AdLIGO Optical configuration and control Nov 10, 2005 Alan Weinstein

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. AdLIGO Optical configuration and control Nov 10, 2005 Alan Weinstein for AdLIGO Interferometer Sensing and Control (ISC)and the 40 meter lab LIGO NSF review, 11/10/05

  2. 40 KG FUSED SILICA ADVANCED LIGO LAYOUT BS Beam Splitter ITM Input Test Mass ETM End Test Mass PD Photodiode PRM Power Recycling Mirror SRM Signal Recycling Mirror AdLIGO optical configuration and control • Problem: If the current Initial LIGO optical configuration (power-recycled Michelson with Fabry-Perot arms) is retained in AdLIGO, the increased laser power (needed for better sensitivity in the high-frequency shot-noise-limited regime) will put intolerable thermal load on the transmissive (absorptive, lossy) optics in the power recycling cavity (BS, ITM substrates). • Solution: increase the finesse (optical gain) of the F-P arms, decrease the gain in the PRC. Garms = 130  770 GPRC = 50  15 LIGO NSF review, 11/10/05

  3. Resonant Sideband Extraction • Problem: Increasing the finesse of the arms causes the cavity pole frequency to decrease, leading to reduced bandwidth for GW signal. fcav = 90  15 Hz • Solution: resonant sideband subtraction! • the PRM acts to increase the optical gain of the arms, for the carrier: Gtot = GarmsGPRC . • the SEM acts to decrease the optical gain of the arms, for the GW signal sidebands – the signal sidebands are resonantly extracted out asymmetric port: f = 15 200 Hz • This decouples the problem of storing the carrier power (CARM+PRC) from extracting the signal (DARM+SEC), allowing us to optimize both for best quantum-limited response to signal, and apportionmentof optical gain / thermal load. • Also produces the potential for beating SQL if thermal noise were overcome. FP cavity Power PRM Laser FP cavity BS GW signal Detuning SEM LIGO NSF review, 11/10/05

  4. f = 2kls = 4pls(fcarr+fsig)/c rCC rITM RSE tuned (narrow band) RSE SR SR The red curve corresponds to r = rITM, ie, no SR mirror Tuning the signal response • Better solution: Detuned signal extraction optimizes the signal extraction for a signal frequency away from DC, allowing us to resonantly enhance the response at, say, 40 Hz, shaping the frequency response to optimize sensitivity in the presence of other noise sources (thermal, seismic.. which are overwhelming near DC). • By choosing the phase advance of the signal (fcarr+fsig) in the signal recycling cavity, can get longer (SR) or shorter (RSE) storage of the signal in the arms: LIGO NSF review, 11/10/05

  5. Using RSE to optimize sensitivity Now we can independently tune hDC and fpolarm to optimize sensitivity (eg, hug the thermal noise curve) ALSO produces optical spring resonance at lower frequencies where radiation pressure becomes important. LIGO NSF review, 11/10/05

  6. Projected Adv LIGO Detector Performance 10-21 • Newtonian background,estimate for LIGO sites • Seismic ‘cutoff’ at 10 Hz • Suspension thermal noise • Test mass thermal noise • Unified quantum noise dominates at most frequencies for fullpower, broadband tuning Optimize detuned RSE response, in the presence of other noise sources, to maximize BNS range. Initial LIGO 10-22 Strain Advanced LIGO 10-23 optical spring;better than SQL! 10-24 10 Hz 100 Hz 1 kHz LIGO NSF review, 11/10/05

  7. Control of the AdLIGO optical configuration • Problem: the detuned signal extraction, on top of the power-recycled Michelson with Fabry-Perot arms, is a very complicated optical configuration. The current Initial LIGO sensing scheme cannot acquire lock and control the mirrors in AdLIGO. • The Initial LIGO scheme uses one pair of RF sidebands for PDH reflection locking of the arms (CARM and DARM) and PRC, and Schnupp transmission locking for the Michelson (MICH). The signals for the short degrees of freedom (PRC and MICH) would be overwhelmed by the large signals from the arms, if the arms weren’t tightly controlled: gain hierarchy. • Solution: enhance the length signal sensing by using two pairs of RF sidebands, used in clever ways. • The signals for the short degrees of freedom (PRC, MICH and SEC) can be completely decoupled from the large signals from the arms; the length sensing matrix is much more diagonal, no gain hierarchy needed. Expect lock acquisition to be more deterministic, control to be more robust! LIGO NSF review, 11/10/05

  8. Carrier (Resonant on arms) -f2 -f1 f1 f2 AdLIGO signal extraction scheme ETMy • Mach-Zehnder installed to eliminate sidebands of sidebands. • Only + f2is resonant on SRC. • Unbalanced sidebands of +/-f2 due to detuned SRC produce good error signal for Central part. • Arm cavity signals are extracted from beat between carrier and f1 or f2. • Central part (Michelson, PRC, SRC) signals are extracted from beat between f1 and f2, not including arm cavity information. 4km f2 ITMy ETMx PRM ITMx BS 4km f1 SRM • Single demodulation • Arm information • Double demodulation • Central part information LIGO NSF review, 11/10/05

  9. 5 DOF for length control Length Sensing Matrix (in-lock) ETMy Phase Modulation f1=33MHz f2=166MHz Ly=38.55m Finesse=1235 ITMy Common of arms CARM Differential arms DARM Power recycling cavity (PRC) Michelson (MICH) Signal extraction cavity (SEC) : L=(Lx Ly) / 2 : L=Lx Ly : l=(lx ly) / 2 =2.257m : l=lx ly = 0.451m : ls=( lsx lsy) / 2 =2.15m GPR=14.5 lsy ETMx Laser ly ITMx BS lx Lx =38.55m Finesse=1235 PRM lsx T=7% SRM T=7% PO SP AP LIGO NSF review, 11/10/05

  10. Full lock of AdLIGO optical configuration at the 40 Meter prototype • Problem: all fine in theory, but does it work in practice? • Solution: Full engineering prototype at 40 meter lab • Apparently so! We use this scheme to acquire lock and control the 40m AdLIGO-prototype interferometer, even during the noisy daytime. • Full lock acquisition is now relatively routine, and robust. • The optical response is precisely as expected, including the resonant enhancement (at the 40m, this is at ~4 kHz; in AdLIGO, it will be at ~200 Hz) as well as the optical spring (40m: ~50 Hz; AdLIGO: ~80 Hz). • In the process, we have learned a great deal about the intricacy of the AdLIGO optical design, and how to control it. • Exploiting the enhanced controls and more diagonal sensing matrix, we are developing deterministic lock acquisition procedures, step-by-step approaches to take the wait and chance out of lock acquisition. TOUR OF 40M LAB AT 5PM. FIVE MINUTE WALK FROM HERE LIGO NSF review, 11/10/05

  11. ETMy Shutter ITMy PRM ETMx ITMx Carrier 33MHz 166MHz BS Shutter SRM The path to full RSE at the 40m Oct. 2004 Detuned dual recycled Michelson Oct. 2005 RSE Nov. 2004 Arm lock with offset in common mode Reducing offset LIGO NSF review, 11/10/05

  12. Optical spring and Optical resonance in differential arm mode of detuned RSE • Optical gain of L- loop • DARM_IN1/DARM_OUT divided by pendulum transfer function • Optical spring and optical resonance of detuned RSE were measured. • Frequency of optical spring depends on cavity power, mass, detuning phase of SRC. • Frequency of optical resonance depends on detuning phase of SRC. • Theoretical line was calculated using A. Buonanno and Y.Chen’s equations. LIGO NSF review, 11/10/05

  13. Frequency sweep of optical spring ~1900W ~270W LIGO NSF review, 11/10/05

  14. Optical spring in E2E • Calculated by time domain simulation • No length control • Lock lasts ~0.7sec, so statistics at low frequency is not good. • Simple length control required • Calculation time ~5min using DRMI summation cavity Hiro Yamamoto LIGO NSF review, 11/10/05

  15. But will it work in AdLIGO? • AdLIGO has • 4 km arms (longer storage time) • quadruple pendulums (much quieter, but also much less actuation force on the test mass) • advanced seismic isolation and quieter environment (much quieter) • Much larger thermal load, thermal compensation • No problems are foreseen, but we must extrapolate from 40m to AdLIGO with detailed simulation -> e2e. • Will maintaining lock be more difficult in Adv LIGO?We might expect it will be significantly easier, because: much quieter seismic platform, powerful multiple pendulum isolation, and more diagonal length sensing plant. • This is an inference that must be verified through tests (LASTI) and simulation (e2e). LIGO NSF review, 11/10/05

More Related