1 / 9

Developing Imaging Calorimeters for a SiD-Flavor Lepton Collider

Developing Imaging Calorimeters for a SiD-Flavor Lepton Collider. Jacob Smith Linear Collider Physics School Ambleside ,England 2009. Resistive Plate Chamber. Gas Electron Multiplier. ILC HCAL Requirements.

elden
Télécharger la présentation

Developing Imaging Calorimeters for a SiD-Flavor Lepton Collider

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Developing Imaging Calorimeters for a SiD-Flavor Lepton Collider Jacob Smith Linear Collider Physics School Ambleside ,England 2009

  2. Resistive Plate Chamber Gas Electron Multiplier LCPS 2009, Jacob Smith

  3. ILC HCAL Requirements • Finely segmented readout on the order of 1 cm2 laterally and longitudinally  50 x 106 • Simple, cheap readout  front-end located on detector and highly multiplexing • Technology able to operate in high magnetic fields • Manageable (radius,cost) coil  thin active medium • Active element and electronics perform reliably over lifetime of experiment 10-20 yrs • Estimated 5000m2 active area  cost effective medium LCPS 2009, Jacob Smith

  4. In The Test BeamFermi National Accelerator Laboratory Meson Test Beam Facility 120 GeVSecondary Pion Mode Single Layer GEM 8 Layer RPC LCPS 2009, Jacob Smith

  5. LCPS 2009, Jacob Smith

  6. RPC Short Term Rate Capabilities Counts Efficiency % Δt [ms] Δt [ms] B.Bilki et al., ‘Measurement of the Rate Capability of Resistive Plate Chambers’, ArXiV 0901.4371, submitted to JINST. LCPS 2009, Jacob Smith

  7. RPC 1 m3 Test Beam z Incident Beam 24 40+ total layers 400 k channels Each 64 pads 1 m y x ~30 cm LCPS 2009, Jacob Smith

  8. Synergy of Analysis: 1m3 CALICE daq c++ c++ Quick event building Final event building CALICE binary binary data ASCII data binary data lcio lccd c++ marlin Event display Conditions data Fortran analysis C++ analysis Analysis ASCII data Test beam Run decision Test beam Run decision ‘Offline analysis’ ‘Online analysis’ Educational purposes only, Previouselypresentat at CALICE TB Metting June 09

  9. Future Plans • 1m3 and 3m3 simulations • GEANT4/Mokka(?) 1. Construction of 1m3 RPC • Write event builder, incorporate with CALICE sw • Cosmic Ray Test Stand (as layers/parts come) 2. Test Beam (shifts) 3. Data Analysis (offline analysis) • Write Papers (5+) • Calibration (muons, pions, multiplicity, efficiency), electron response, hadronic shower response (shower shape, response, longitudinal development) 5. Get PhD! LCPS 2009, Jacob Smith

More Related