1 / 16

Lecture 23

Lecture 23. ANNOUNCEMENTS Midterm #2 results (undergrad. scores only): N=73; mean=63 ; median=63.5 ; std.dev.=8.42 You may pick up your exam during any TA office hour. Regrade requests must be made before you leave with your exam.

jensen
Télécharger la présentation

Lecture 23

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Lecture 23 ANNOUNCEMENTS • Midterm #2 results (undergrad. scores only): • N=73; mean=63; median=63.5; std.dev.=8.42 • You may pick up your exam during any TA office hour. • Regrade requests must be made before you leave with your exam. • The list of misunderstood/forgotten points has been updated. OUTLINE • BJT Differential Amplifiers (cont’d) • Cascode differential amplifiers • Common-mode rejection • Differential pair with active load Reading: Chapter 10.4-10.6.1 6 44 21

  2. Cascode Differential Pair Half circuit for ac analysis

  3. Telescopic Cascode Differential Pair Half circuit for ac analysis

  4. Example Half circuit for ac analysis

  5. Effect of Finite Tail Impedance • If the tail current source is not ideal, then when an input common-mode voltage is applied, the currents in Q1 and Q2 and hence the output common-mode voltage will change.

  6. Effect of Input CM Noise Ideal Tail Current • There is no effect of the input CM noise at the output.

  7. Effect of Input CM NoiseNon-Ideal Tail Current • The single-ended outputs are corrupted by the input CM noise.

  8. Comparison • The differential output voltage signal is the same for both cases.  For small input CM noise, the differential pair is not affected. Ideal Tail Current Non-Ideal Tail Current

  9. CM to DM Conversion; gain ACM-DM • If finite tail impedance and asymmetry (e.g. in load resistance) are both present, then the differential output signal will contain a portion of the input common-mode signal.

  10. Example

  11. Common-Mode Rejection Ratio • CMRR is the ratio of the wanted amplified differential input signal to the unwanted converted input common-mode noise that appears at the output.

  12. Differential to Single-Ended Conversion • Many circuits require a differential to single-ended conversion. • This topology is not very good; its most critical drawback is supply noise corruption, since no common-mode cancellation mechanism exists. Also, we lose half of the voltage signal.

  13. … A Better Alternative • This circuit topology performs differential to single-ended conversion with no loss of gain.

  14. Active Load • With a current mirror as the load, the signal current produced by Q1 can be replicated onto Q4. • This type of load is different from the conventional “static load” and is called an “active load.”

  15. Differential Pair with Active Load • The input differential pair decreases the current drawn from RL by I, and the active load pushes an extra I into RL by current mirror action; these effects enhance each other.

  16. Active Load vs. Static Load • The load in the circuit on the left responds to the input signal and enhances the single-ended output, whereas the load in the circuit on the right does not.

More Related