1 / 10

Danielle Tague Khadija Mitchell

Real World Project: Using HPLC and SFE to determine amounts of caffeine in different coffee samples. Danielle Tague Khadija Mitchell. Purpose. Determination of the amount of caffeine in decaf and caffeinated ground coffee and coffee beans was done using HPLC.

keren
Télécharger la présentation

Danielle Tague Khadija Mitchell

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Real World Project:Using HPLC and SFE to determine amounts of caffeine in different coffee samples Danielle TagueKhadija Mitchell

  2. Purpose Determination of the amount of caffeine in decaf and caffeinated ground coffee and coffee beans was done using HPLC. Extraction of caffeine from each sample was done by SFE. The amounts of caffeine determined using HPLC were compared with the amounts of caffeine extracted using SFE.

  3. Data: SFE • We weighed the flasks before and after the extraction and took the differences to determine amounts extracted. • The ground caffeinated coffee sample did not yield results we would have expected – if any caffeine was extracted at all it was a very minimal amount. • The other samples showed results we expected, low amounts of caffeine in decaf samples and a higher amount in the caffeinated sample.

  4. Data: HPLC From Original Samples • Dissolved 50 mg samples in 50 mL distilled water over heat. • Bean samples did not completely dissolve

  5. Original Samples • Concentration of caffeine in the ground decaff sample was lower than caffeinated as expected • Concentrations in the beans were low (due to difficulty in dissolving beans)

  6. Data: HPLC From SFE • Left over sample from SFE, 50 mg, was dissolved in 50 mL distilled water. • Bean samples did not completely dissolve. • Caffeine extract was dissolved in 50 mL distilled water. (methanol or chloroform)

  7. Samples from SFE • The values of the two ground samples were too close • Bean samples were low because it was hard to dissolve • Inconclusive and low data for the extracted caffeine because it was not able to bedissolved.

  8. Conclusion of Results Caffeinated samples were higher as expected Decaff was not as low as expected Bean samples were not reliable because they didn’t dissolve completely – but caffeinated beans still had higher results Extracted caffeine was also useless because it did not dissolve and results were inconclusive The left over samples from SFE should have been lower since the caffeine was extracted from them

  9. Error Our extracted caffeine should have been dissolved in either methanol or chloroform rather than water We did not initially do this to be consistent with other samples We could have reran the samples through the SFE again to attempt to extract more but we ran out of time

More Related