1 / 21

Electronics

Electronics. Dan Simon Cleveland State University ESC 120. Voltage. Voltage is the amount of work needed to move an electric charge High voltage in an electrical system is like high pressure in a hydraulic system

lani
Télécharger la présentation

Electronics

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Electronics Dan SimonCleveland State UniversityESC 120 Revised August 28, 2010

  2. Voltage • Voltage is the amount of work needed to move an electric charge • High voltage in an electrical system is like high pressure in a hydraulic system • Common outlets in the United States: 120 Volts, 60 Hertz, alternating current (AC)

  3. Current • Electric current: The flow of electric charge (electrons), measured in Amperes • One amp of current means a flow of one Coulomb (6.241 × 1018 electrons) per second • Amps = Coulombs / second • High current in an electrical system is like high rate of flow in a hydraulic system

  4. Power • Power: The rate at which current flows, measured in Watts • Power is the product of voltage and current • Watts = Volts × Amps • Typical power consumption • Air conditioner: 2000 W • Clock: 2 W • Television: 200 W • Light bulb: 100 W Ohio’s average electricity cost: 12 cents per kW-hr

  5. Resistors A resistor reduces the rate of flow of electric current, measured in Ohms: V = IR Example: If R1 > R2, then the current through R1 will be less than the current through R2

  6. Resistor Combinations Series: R = R1 + R2 Parallel: R = 1 / (1/R1 + 1/R2)

  7. Potentiometer Trimpot Adjuster

  8. Capacitors Capacitors store electrical energy

  9. Transistors Transistors can be used as electrically-controlled switches. The current through the transistor is proportional to the voltage applied to the base.

  10. Diodes Diodes allow current to flow only in one direction.Light-emitting diodes (LEDs) emit light.The long lead connects to the positive voltage. Current flow

  11. Solderless Breadboard

  12. Breadboard Internal connections in orange

  13. Wire and Wire Strippers

  14. Multimeter Measures voltage, current, and resistance. If you get unpredictable readings, check the battery!

  15. Power Supply Regulated 5 Volt power supply: “wall wart” You need to cut off the connector so that you can connect the bare wires to your breadboard

  16. Breadboard Breadboard with connector posts, ready for power supply connections

  17. LED Experiment Resistor value should be at least 400 ohms

  18. Potentiometer Experiment

  19. Motor Experiment

  20. Motor Experiment

More Related