1 / 12

Electronic Engineering Final Year Project

Electronic Engineering Final Year Project. Final Year Project Presentation Title: Trailer Reverse Control System Author : Marco Law (Chun Ip) Supervisor: Dr. Martin Glavin. Topics. Project Overview Approach Project Outcome Conclusion. Project Overview.

montana
Télécharger la présentation

Electronic Engineering Final Year Project

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Electronic Engineering Final Year Project Final Year Project Presentation Title: Trailer Reverse Control System Author: Marco Law (Chun Ip) Supervisor: Dr. Martin Glavin

  2. Topics • Project Overview • Approach • Project Outcome • Conclusion

  3. Project Overview When a driver is caught in a situation where reversing is the only option to get out of a dead-end or a tight corner, especially with a trailer attached to the vehicle, it is quite a difficult task, even to some experienced drivers.

  4. Project Overview “Jack-knifing” It is defined as the condition when a vehicle towing a trailer, it gets to such an acute angle that causing it to bend or fold up and it can no longer be manoeuvred in reverse.

  5. Project Overview Objective of the project: In order to prevent “jack-knife”, this project used equations to describe the motion and the orientation of the trailer and the vehicle which then implentmented to Matlab, where a number of input parameters were plotted in a graph, predicting and displaying the positions of the vehicle and the trailer when reversed in a distance.

  6. Key input of parameters of the project • Current angle between the vehicle and trailer • Steering angle (fi1) • Angle between the wheel of trailer and the X-axis (fi2) • Length of trailer's towbar • Length of the trailer (L) • Length from the front wheel to the vehicle's towbar (M)

  7. Approach The system was developed by using the equations which describe the behaviour of the vehicle and the trailer. The differential equations describing its movement: x1 = V*cos (fi1) y1 = V*sin (fi1) fi1' = w

  8. Approach The position and orientation of the trailer: x3= V*cos(fi1 – fi2)*cos(fi2)+M*w*sin (fi1-fi2)*cos(fi2) y3= V*cos(fi1 – fi2)*sin(fi2)+M*w*sin (fi1-fi2)*sin(fi2) fi2' = 1/ L+l1 ( V*sin (fi1-fi2) + M*w*cos (fi1 – fi2)

  9. Approach Assuming the vehicle is travelling at a constant speed of 0.05m/s (V), the radius of the wheel is 2.5cm and the angular velocity (w) of the vehicle is then calculated – angular velocity = 2 rads/sec

  10. Project Outcome When the calculated values were put in the equations, the results of the plots were unexpected, the position of the trailer seemed to be uncorrected. The position of the vehicle (x1,y1) and the towbar (x2,y2) appeared correct but the rear axle of the trailer (x3,y3) was shifted to one side of the plot.

  11. Project Outcome

  12. Conclusion When the input parameters were inserted into the differential equations, the results and the plots in matlab generated in such a way that the position of the trailer were not quite expected to be, although a number of approaches were taking towards the problem, however, the solution to the problem is remain undefined.

More Related