1 / 5

On-Line Cutting of LOVA Nitramine Gun Propellant

On-Line Cutting of LOVA Nitramine Gun Propellant. Wayne Thomas William Newton Naval Surface Warfare Center Indian Head Division. Cutter Design History. We had to design a method of cutting LOVA strands remotely for the twin screw extruder.

orien
Télécharger la présentation

On-Line Cutting of LOVA Nitramine Gun Propellant

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. On-Line Cutting of LOVA Nitramine Gun Propellant Wayne Thomas William Newton Naval Surface Warfare Center Indian Head Division

  2. Cutter Design History • We had to design a method of cutting LOVA strands remotely for the twin screw extruder. • The manual method of cutting strands is not applicable. • This strand cutting method is a very innovative technology in the continuous processing of LOVA propellant.

  3. MANUAL FEED CUTTER • This cutter uses a rotating blade against a brass block. • This technology is approximately 60 years old. • This used for various formulations.

  4. ON LINE CUTTER • The basic premise of this cutter is to replace the person in the “Manual Feed Cutter”. • The strand is cut using a blade rotating past a brass block.

  5. CAPABILITIES OF THE ON LINE CUTTER • The cutter can cut strands from 0.25” to 0.75” in diameter. • The cutter can handle strand linear speed rates up to 50 ipm at maximum diameter. • The cuts are more uniform because the strand is indexed, stopped and then cut. • This is possible because the strand handling and cutting is handled by computer controlled motors. • At our new 88mm extruder we will be cutting 8 strands.

More Related