How to Resolved HP Printer Feeding Paper Crooked

1. How to Resolved HP Printer Feeding Paper Crooked The paper feeder of the HP printer gets crooked due to various reasons. The printer produce noise while printing but will not load the paper. Read the below-given methods, that will help you to solve the paper feed issue. A Quick Solution to Resolve the Paper Feeding Issue 1.Reset your printer to fix most of the printer errors. 2.Check if the HP printer is power on, and detach the cable from the rear of the printer. 3.Disconnect the power cord connected to the electrical wall cavity. 4.Replug the wires after a minute or two. 5.Load the input tray with a new stack of paper. 6.Check the quality and type of paper inserted. 7.Power on the printer, and carry out a self-test report. 8.Print the original if the test print is successful. A Complete Solution to Solve the Paper Feed Issue in HP Printer ➔Resetting the printer will crack most of the printer issues. Before you begin printing, check if the paper stuffed is untorn, dusty, wrinkled or folded. ➔Draw out the paper from the input tray, and check if there is any obstacle inside the tray. ➔The quality of the paper is also significant for better printing results. Read the product specification, and buy better quality paper from the HP Store. ➔Load only the required number of sheets to prevent a paper jam. The paper loaded in the stack should be of the same size. If all the above-mentioned tips are followed, then the paper feed issue can be prevented. ➔To reload the paper, the paper width guides should be slide to its outermost position. Press the guides against the paper so that the paper does not move. ➔Print a test report. If the printer could print freely without issues, you can print the original. If the error persists, try other methods to fix it. ➔By cleaning the paper rollers, you can stop paper feed issues. To do so, cancel the print jobs, and power the printer off. The power cord connected to the electrical socket should be removed, and the cable from the rear of the printer should be disconnected. ➔Lift the input tray. Use a flashlight, and locate the gray paper pick. Remove the dirt or dust from the paper rollers. Leave the rollers to dry for 10 minutes.

2. ➔Reconnect the cable, and power on the printer. You can also wipe the rollers using a soft cloth. Modify the paper settings if the paper size mentioned does not match with the paper size loaded. The printer will not feed paper if this is the case. Perform a self - test report, the paper feed error would have cleared.