1 / 8

Workshop on Thermal Boundary Conditions

Workshop on Thermal Boundary Conditions. Y. Several thermal boundary conditions will be explored in this workshop modifying the flow on labyrinth case given on LE#1. This section gives a few definitions on thermal boundary conditions before to proceed to the workshop itself. . X.

seanna
Télécharger la présentation

Workshop on Thermal Boundary Conditions

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Workshop on Thermal Boundary Conditions Y Several thermal boundary conditions will be explored in this workshop modifying the flow on labyrinth case given on LE#1. This section gives a few definitions on thermal boundary conditions before to proceed to the workshop itself. X

  2. Blockages and Plates It is possible to specify at a blockage made of solid material (> 99) or at a plate : • A fixed temperature at the blockage or at the plate • A fixed heat flux W/m2 for plates and W/m3 for blockages • Adiabatic. For a blockage where a solid material was selected there is no heat source but the blockage may conduct heat! • Linear Heat Source specifies a heat flux due to the convective heat transfer coefficient; q = h(Tamb-Tcell)

  3. Special Case: Non-ParticipatingBlockages Non-participating blockages are defined by ‘other materials’ (not sólid, or líquid or gas) which, despite of not conducting heat they may have heat sources at their faces:

  4. Part I - IsothermalFlow • Upload exercise from LE#1 • Extend the domain accordingly to the figure • Insert: one blockage, one inlet and one outlet (they are reversed) • The fluid is air and the same inlet velocities are applied: 5m/s. • Adjust the grid for the new objects for 3 and 5 volumes along the y direction 0.005 0.003 0.015 Y X 0.025

  5. Part II(a) – HeatTransfer Case • Activate the energy equation • Upper channel: Tin = 200oC • Labyrinth: Tin = 20oC • Made the dividing wall and the pin of cooper, and set them adiabatic. • Keep B1 as material 198 but set the East face T = 200oC and the North face h = 100W/m2/oC with Tamb = 200oC. cooper Y B1 X

  6. Part II – Results (TemperatureProfile) • The hot stream transfer heat to the cold stream through convection-conduction-convection. • The dividing block and the pin transfer heat by conduction only. • Notice that dividing block and the pin were set as adiabatic, therefore there is no heat source on them. • The faces East and North of block B1 have energy sources. • The gray block is of material 198 without any heat source therefore it does not participate on the energy balance.

  7. Part III – HeatTransfer Case • Replace the upper channel fluid by water • Compare your results and comments the differences on the temperature field. • Case where heat convection is coupled with heat conduction are referred to conjugate heat transfer. Air-Air • Water-Air Upload this case q1 you need Upload this case q1 you need

  8. PossibleVariations • If you have a spare time try to: • Change the conducting properties of the dividing wall • Change the conducting properties of the pin (make it work as an heat insulator) • THE END

More Related