1 / 16

DESIGN AND DEVELOPMENT OF LOW COST ARM CORTEX-M BASED EVALUATION BOARD

DESIGN AND DEVELOPMENT OF LOW COST ARM CORTEX-M BASED EVALUATION BOARD. KALPATARU INSTITUTE OF TECHNOLOGY, Tiptur . DEPARTMENT OF ELECTRONICS AND COMMUNICATION ENGINEERING. Head of the Department, Dr. RAJASHEKARARADYA Professor & HOD, Dept. of ECE K.I.T Tiptur. Under the guidance of,

vesta
Télécharger la présentation

DESIGN AND DEVELOPMENT OF LOW COST ARM CORTEX-M BASED EVALUATION BOARD

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. DESIGN AND DEVELOPMENT OF LOW COST ARM CORTEX-M BASED EVALUATION BOARD KALPATARU INSTITUTE OF TECHNOLOGY, Tiptur. DEPARTMENT OF ELECTRONICS AND COMMUNICATION ENGINEERING Head of the Department, Dr. RAJASHEKARARADYA Professor & HOD, Dept. of ECE K.I.T Tiptur. Under the guidance of, NIRANJANA SWAMY G S Asst. professor, Dept. of ECE K.I.T Tiptur Submitted By, LAVANYA H M (1KI10EC091)

  2. INTRODUCTION • Development board is a printed circuit board with circuitry and hardware to facilitate experimentation with certain microcontroller. • Every engineer, developer or hobbyist must have development board to implement their ideas. • LPC1768 evaluation board is based on ARM Cotex-M3 processor from NXP. • LPC1768 Development board should be low cost, less power consumption, and high processing speed.

  3. Block diagram

  4. FEATURES • In-System Programming and In-Application Programming. • 8 Channel DMA controller. • Ethernet MAC. • 4 UARTs. • 2 CAN channels. • 3 SSP/SPI. • 3 I2C • I2S. • 8 Channel 12-bit ADC. • 10 bit DAC. • Motor controll PWM. • Quadrature encoder interface. • 4 General purpose timer. • Watchdog timer.

  5. Software and hardware • Keil MDK-ARM software for Application development • Altium for PCB Designing, PCB board and all the semiconductor components including LPC1768 micro-controller.

  6. THANK YOU

More Related