1 / 6

Setting Up OpenLab for Snapper and Orca Control

This guide explains how to configure OpenLab for Snapper Dig-16 and Orca (C4742-95) settings. Begin by launching the OpenLab application and accessing the Video Manager. Choose Snapper Dig-16 and adjust the settings as shown. Next, navigate to OpenLab preferences, select Ludl, and configure the number of controllers to 2. Under serial ports, assign the appropriate ports for CRI RGB and Ludl controllers as follows: "SXProS2P4.4" for CRI RGB, "SXProS2P3.3" for Ludl1, and "SXProS2P2.2" for Ludl2. Follow these steps for optimal setup.

armand-larson
Télécharger la présentation

Setting Up OpenLab for Snapper and Orca Control

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Go to applications, start openlab, and open videomanager

  2. Select snapper dig-16 and all of the other settings shown here

  3. Select Orca (C4742-95)

  4. Go to Openlab preferences and select Ludl, then select number of controllers as 2

  5. Go to serial ports and select ports for CRI RGB as “SXProS2P4.4” and select Ludl1 as “SXProS2P3.3”

  6. select Ludl2 as “SXProS2P2.2”

More Related