1 / 32

Chapter 13 – Solutions - part II Colligative Properties

Chapter 13 – Solutions - part II Colligative Properties. Changes in colligative properties depend only on the number of solute particles present, not on the identity of the solute particles. Among colligative properties are Vapor pressure lowering Boiling point elevation

Télécharger la présentation

Chapter 13 – Solutions - part II Colligative Properties

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Chapter 13 – Solutions - part IIColligative Properties • Changes in colligative properties depend only on the number of solute particles present, not on the identity of the solute particles. • Among colligative properties are • Vapor pressure lowering • Boiling point elevation • Melting point depression • Osmotic pressure

  2. Vapor Pressure Because of solute-solvent intermolecular attraction, higher concentrations of nonvolatile solutes make it harder for solvent to escape to the vapor phase. Therefore, the vapor pressure of a solution is lower than that of the pure solvent.

  3. Raoult’s Law PA = XAPA where • XA is the mole fraction of compound A • PA is the normal vapor pressure of A at that temperature NOTE: This is one of those times when you want to make sure you have the vapor pressure of the solvent.

  4. Boiling Point Elevation and Freezing Point Depression Nonvolatile solute-solvent interactions also cause solutions to have higher boiling points and lower freezing points than the pure solvent.

  5. 0 DTb = Tb – T b 0 T b is the boiling point of the pure solvent 0 Tb > T b DTb = Kbm Boiling-Point Elevation T b is the boiling point of the solution DTb > 0 m is the molality of the solution Kb is the molal boiling-point elevation constant (0C/m)

  6. Boiling Point Elevation The change in boiling point is proportional to the molality of the solution: Tb = Kb  m where Kb is the molal boiling point elevation constant, a property of the solvent. Tb is added to the normal boiling point of the solvent.

  7. Freezing Point Depression • The change in freezing point can be found similarly: Tf = Kf  m • Here Kf is the molal freezing point depression constant of the solvent. Tf is subtracted from the normal freezing point of the solvent.

  8. 0 DTf = T f – Tf 0 T f is the freezing point of the pure solvent 0 T f > Tf DTf = Kfm Freezing-Point Depression T f is the freezing point of the solution DTf > 0 m is the molality of the solution Kf is the molal freezing-point depression constant (0C/m)

  9. Note that in both equations, T does not depend on what the solute is, but only on how many particles are dissolved. Tb = Kb  m Tf = Kf  m Boiling Point Elevation and Freezing Point Depression

  10. 0 DTf = T f – Tf moles of solute m= mass of solvent (kg) = 3.202 kg solvent 1 mol 62.01 g 478 g x 0 Tf = T f – DTf What is the freezing point of a solution containing 478 g of ethylene glycol (antifreeze) in 3202 g of water? The molar mass of ethylene glycol is 62.01 g. DTf = Kfm Kf water = 1.86 0C/m = 2.41 m DTf = Kfm = 1.86 0C/m x 2.41 m = 4.48 0C = 0.00 0C – 4.48 0C = -4.48 0C

  11. Colligative Properties of Electrolytes Since these properties depend on the number of particles dissolved, solutions of electrolytes (which dissociate in solution) should show greater changes than those of nonelectrolytes.

  12. Colligative Properties of Electrolytes However, a 1 M solution of NaCl does not show twice the change in freezing point that a 1 M solution of methanol does.

  13. van’t Hoff Factor One mole of NaCl in water does not really give rise to two moles of ions. Some Na+ and Cl− reassociate for a short time, so the true concentration of particles is somewhat less than two times the concentration of NaCl.

  14. The van’t Hoff Factor • Reassociation is more likely at higher concentration. • Therefore, the number of particles present is concentration dependent. • We modify the previous equations by multiplying by the van’t Hoff factor, i Tf = Kf  m i

  15. actual number of particles in soln after dissociation van’t Hoff factor (i) = number of formula units initially dissolved in soln Colligative Properties of Electrolyte Solutions 0.1 m NaCl solution 0.1 m Na+ ions & 0.1 m Cl- ions Colligative properties are properties that depend only on the number of solute particles in solution and not on the nature of the solute particles. 0.1 m NaCl solution 0.2 m ions in solution i should be 1 nonelectrolytes 2 NaCl CaCl2 3

  16. Boiling-Point Elevation DTb = iKbm Freezing-Point Depression DTf = i Kfm p = iMRT Osmotic Pressure (p) Colligative Properties of Electrolyte Solutions

  17. Change in Freezing Point • Which would you use for the streets of Bloomington to lower the freezing point of ice and why? Would the temperature make any difference in your decision? • sand, SiO2 • Rock salt, NaCl • Ice Melt, CaCl2

  18. Change in Freezing Point Common Applications of Freezing Point Depression Ethylene glycol – deadly to small animals Propylene glycol

  19. Change in Boiling Point Common Applications of Boiling Point Elevation

  20. Freezing Point Depression At what temperature will a 5.4 molal solution of NaCl freeze? Solution ∆TFP = Kf • m • i ∆TFP = (1.86 oC/molal) • 5.4 m • 2 ∆TFP = 20.1oC FP = 0 – 20.1 = -20.1oC

  21. Osmosis • Some substances form semipermeable membranes, allowing some smaller particles to pass through, but blocking other larger particles. • In biological systems, most semipermeable membranes allow water to pass through, but solutes are not free to do so.

  22. Osmosis In osmosis, there is net movement of solvent from the area of higher solvent concentration (lowersoluteconcentration) to the are of lower solvent concentration (highersoluteconcentration).

  23.  =()RT = MRT n V Osmotic Pressure • The pressure required to stop osmosis, known as osmotic pressure, , is where M is the molarity of the solution If the osmotic pressure is the same on both sides of a membrane (i.e., the concentrations are the same), the solutions are isotonic.

  24. Molar Mass from Colligative Properties We can use the effects of a colligative property such as osmotic pressure to determine the molar mass of a compound.

  25. Osmosis in Blood Cells • If the solute concentration outside the cell is greater than that inside the cell, the solution is hypertonic. • Water will flow out of the cell, and crenation results.

  26. Osmosis in Cells • If the solute concentration outside the cell is less than that inside the cell, the solution is hypotonic. • Water will flow into the cell, and hemolysis results.

  27. A cell in an: isotonic solution hypotonic solution hypertonic solution

  28. Chemistry In Action: Desalination

  29. Colloids versus Suspensions • These are mixed, but not dissolved in each other • Will settle over time • Particles are bigger than 1 micrometer (larger than colloid) • Examples: dust in air, muddy water Suspensions of particles larger than individual ions or molecules, but too small to be settled out by gravity.

  30. Tyndall Effect • Colloidal suspensions can scatter rays of light. • This phenomenon is known as the Tyndall effect.

  31. Colloids in Biological Systems Some molecules have a polar, hydrophilic (water-loving) end and a nonpolar, hydrophobic (water-hating) end.

  32. Colloids in Biological Systems Sodium stearate is one example of such a molecule. These molecules can aid in the emulsification of fats and oils in aqueous solutions.

More Related