Calorimetry - 1

1. Calorimetry - 1 Mauricio Barbi University of Regina TRIUMF Summer Institute July 2007

2. Some Literature “Detector for Particle Radiation”, Konrad Kleinknecht, Cambridge University Press “Introduction to Experimental Particle Physics”, Richard Fernow, Cambridge University Press “Techniques in calorimetry”, Richard Wigmans, Cambridge University Press Particle Data Group (PDG): http://pdg.lbl.gov/ Thanks to Michele Livan (INFN and Pavia University) for letting me use some of his material and examples in these lectures

3. Principles of Calorimetry (Focus on Particle Physics) Lecture 1: Introduction Interactions of particles with matter (electromagnetic) Definition of radiation length and critical energy Lecture 2: Development of electromagnetic showers Electromagnetic calorimeters: Homogeneous, sampling. Energy resolution Lecture 3: Interactions of particle with matter (nuclear) Development of hadronic showers Hadronic calorimeters: compensation, resolution

4. Introduction Bomb calorimeter  http://en.wikipedia.org/wiki/Calorimeter:  A calorimeter is a device used for calorimetry  Calorimetry is the science of measuring the heat generated or absorbed in a chemical reaction or physical process.  The word Calorimeter comes from the Latin calor meaning heat, and from the Greek metry meaning to measure.  A primitive calorimeter was invented by Benjamin Thompson (17th century) “When a hot object is set within the water, the system's temperature increases. By measuring the increase in the calorimeter's temperature, factors such as the specific heat (the amount of heat lost per gram) of a substance can be calculated.”(http://www.bookrags.com/Calorimeter)

5. Substance c in J/gm K c in cal/gm K Aluminum 0.9 0.215 Bismuth 0.123 0.0294 Copper 0.386 0.0923 Brass 0.38 0.092 Gold 0.126 0.0301 Lead 0.128 0.0305 Silver 0.233 0.0558 Tungsten 0.134 0.0321 Zinc 0.387 0.0925 Mercury 0.14 0.033 Alcohol(ethyl) 2.4 0.58 Water 4.186 1 Ice (-10 C) 2.05 0.49 Granite 0.79 0.19 Glass 0.84 0.2 Introduction Specific heat is the amount of heat per unit mass required to raise the temperature by one Kelvin: Q = heat added (energy) c = specific heat m = mass T = change in temperature

6. How to measure the energy of a particle? Let’s consider that we have a calorimeter with 1 liter of water as absorber. Using the formula and table from previous slide, let’s solve the following problems? What is the effect of a 1 GeV particle (e.g., at LHC) in the calorimeter? This is a far too small temperature change to be detected in the calorimeter. New techniques of detection are needed in particle physics. Introduction

7. Introduction Still at http://en.wikipedia.org/wiki/Calorimeter: In particle (and nuclear) physics, acalorimeteris a component of a detector that measures theenergy of entering particles

8. Introduction Main goals: Provide information to fully reconstruct the 4-vector p= (E,p) of a particle Complementary to tracking detectors at very high energies: Provide particle ID based on different energy deposition pattern for different particles species (e/π, etc) Though neutrinos are not directly detected, they can be identified from the missing energy needed for energy conservation to hold Segmentation of the calorimeter can also provide space coordinates of particles. Time information also possible with high resolution achievable Usually important in removing background (cosmic rays, beam spills, etc)

9. Introduction Basic principles: Sensitive to both charged (e±, ±, π±, etc) and neutral particles (, π0, etc) Total energy absorption Particle is “completely destroyed” Destructive process The mechanism evolves as: Entering particle interact with matter Energy deposition by development of showers of decreasingly lower-energy particles produced in the interactions of particle with matter Electromagnetic showers  produced by electromagnetic processes Hadronic showers  produced by hadronic processes (+ EM components) The energy of the particles produced in the showers is converted into ionization or excitation of the matter which compounds the calorimeter energy loss The calorimeterresponseis proportionalto theenergyof the enteringparticle (note the statistical process in the previous item)  σ(E)/E=A/E-1/2

10. Introduction Calorimeter is a complicate device: Particle has to be completely absorbed in order to have its energy fully detected Depends on detector material, its size and geometry Several things happen during this process Showers are product of competing physics interactions between particle and matter Again, this depends on detector material Particle ID and energy measurement through development of showers (with exception of muons) Statistical processes  fluctuations  detector resolution Depends on the energy of the particle, calorimeter uniformity, etc Detector material, its size and geometry to fully contain the showers Different calorimeter types for different physics goals Faster response? Better energy resolution? Spatial coordinates? Hadronic particles? EM particles? Etc…..

11.   εL   Atomic electron atom εK e Free electron Introduction Compton scattering More about EM interaction of particle with matter in this lecture Development of showers and energy resolution in the next lecture EM shower in a sampling calorimeter

12. Introduction Some applications of calorimetry in particle physics Basic mechanism used in calorimetry in particle physics to measure energy Cherenkov light Scintillation light Ionization charge

13. Introduction Neutrino physics Super-Kamiokande (SK) - Japan Measurement of neutrino oscillations Water as active material Energy measurement through Cherenkov radiation ~12K PMTs 50K metric ton of water

14. Introduction 3000 Km2 Ultra high energy cosmic ray The Pierre Auger Observatory (world’s largest calorimeter) Measure charged particles with E > 1019 eV Atmosphere as the calorimeter Surface detectors to measure energy and shower profile Air shower 16K water Cherenkov detectors

15. Introduction Rear calorimeter Collider experiments ZEUS at HERA e-p collider, Germany Study the proton structure and confront QCD predictions Uranium-scintillator sampling calorimeter Energy measured using scintillating light Forward calorimeter Central tracking Barrel calorimeter

16. Muon Detectors Electromagnetic Calorimeters Forward Calorimeters Solenoid EndCap Toroid Barrel Toroid Inner Detector Hadronic Calorimeters Shielding Introduction Collider experiments ATLAS at LHC p-p collider, Switzerland Search for Higgs, SUSY particles, CP violation, QCD, etc Liquid Argon/Pb (EM) and Cu (or W) (Hadron) sampling Calorimeter Energy measured using ionization in the liquid argon

17. Interactions of Particles with Matter We have seen that the calorimeter is based on absorption It is important to understand how particles interact with matter Several physics processes involved,mostly of electromagnetic nature Energy deposition,or loss, mostly byionization or excitation of matter One can initially separate the interactions into two classes Electromagnetic (EM) processes (this lecture): Main photon interactions with matter: Compton scattering Pair Production Photoelectric effect Main electron interactions with matter: Bremsstrahlung Ionization Cherenkov radiation (not covered in this lecture) Hadronic processes: more complicate business than EMnuclear interactions between hadrons (charged or neutral) and matter

18. Interactions of Particles with Matter ρ x Interactions of Photons For a beam of photons traversinga layer of material (Beer-Lambert’s law): α = /ρis calledmass absorption coefficient. Also, λ =α-1 [g/cm2] =photonmassattenuation length Probability that the photon will interact in thicknessXof material

19. Interactions of Particles with Matter http://pdg.lbl.gov Interactions of Photons Photon attenuation lengthfor different elemental absorbersversusphoton energy Note the different patterns for different elements  different response to photons as a function of the photon energy Why?  Next slide

20. Interactions of Particles with Matter Interactions of Photons Cross-section for photon absorption Total cross-sectionσfor photon absorption is related to the total mass attenuation lengthλ: Several processes contribute to the total cross-section: The “+…”in the above expression includes: Rayleigh scattering, where the atom is neither ionized or excited Photonuclear absorption Therefore, different processes contributes with different attenuations: http://pdg.lbl.gov

21. Interactions of Particles with Matter Interactions of Photons Cross-section for photon absorption Since a calorimeter has to fully absorb the energy of an interacting photon: Important to understand the cross-sections as a function of the photon energy in different material Will ultimately define the geometry and composition of a calorimeter The cross-section calculations are difficult due to atomic effects, but there are fairly good approximations: Depend on the absorber material Depend on the photon energy Let’s then visit some of the processes cited in the previous slide

22. Interactions of Particles with Matter p.e. cross-section in Pb Interactions of Photons Photoelectric effect Can be considered as an interaction between a photon and an atom as a whole Can occur if a photon has energy E > Eb (Eb = binding energy of an electron in the atom). The photon energy is fully transferred to the electron Electron is ejected with energyT = E - Eb Discontinuities in the cross-section due to discrete energies Eb of atomic electrons (strong modulations at E=Eb; L-edges, K-edges, etc) Dominating process at low ’s energies ( < MeV ).  Gives low energy electrons Kleinknecht E

23. Interactions of Particles with Matter εL εK p.e. cross-section in Pb Interactions of Photons Photoelectric effect  Cross-section: Let (reduced photon energy) For εK < ε < 1( εK is the K-absorption edge): Forε >> 1(“high energy” photons): σp.e goes withZ5/ε εK ε = 1 E

24.   εL   Atomic electron atom εK e Free electron Interactions of Particles with Matter Interactions of Photons Compton scattering  A photon with energy E,in scatters off an (quasi-free) atomic electron  A fraction of E,in is transferred to the electron  The resulting photon emerges with E,out < E,in and at different direction Using conservation of energy and momentum: The energy of the outgoing photon is: , where E

25. http://www.mathcad.com/Library/LibraryContent/MathML/compton.htmhttp://www.mathcad.com/Library/LibraryContent/MathML/compton.htm Interactions of Particles with Matter Coherent scattering (Rayleigh) E,out / E,in Incoherent scattering (electron is removed from atom) Interactions of Photons Compton scattering  The energy transferred to the electron: Two extreme cases of energy loss:   0 : E,out  E,in ; Te  0  No energy transferred to the electron Backscattered at = π: Compton edge εK ε = 1 E,in [MeV] E

26. Interactions of Particles with Matter http://www.mathcad.com/Library/LibraryContent/MathML/compton.htm Incoherent scattering only Interactions of Photons Compton scattering Total Compton cross-section per electron given by Klein-Nishina (QED) (1929): . Two extreme cases: ε << 1:  Backward-forward symmetry in  distribution ε >> 1:   distribution peaks in the forward direction Cross-section per atom: Includes coherent and incoherent scattering

27.  + e-  e+ + e- + e-  + nucleus e+ + e- + nucleus Interactions of Particles with Matter Interactions of Photons Pair Production  An electron-positron pair can be created when (and only when) a photon passes by the Coulomb field of a nucleus or atomic electron  this is needed for conservation of momentum. Threshold energy for pair production at E = 2mc2 near a nucleus. E = 4mc2near an atomic electron  Pair production is the dominant photon interaction process at high energies. Cross- section from production in nuclear field is dominant. First cross-section calculations made by Bethe and Heitler using Born approximation (1934).

28. Interactions of Particles with Matter Interactions of Photons Pair Production (Attenuation length) The interesting energy domain is that of several hundred MeV or more, . The cross- section per nucleus is: Does not depend on the energy of the photon, but Mass attenuation length for pair creation (check few slides ago): or Accurate to within a few percent down to energies as low as 1 GeV X0is calledradiation lengthand corresponds to a layer thickness of material where pair creation has a probabilityP = 1 – e-7/9  54%

29. Interactions of Particles with Matter P=54% Interactions of Photons Pair Production Photon pair conversion probability http://pdg.lbl.gov

30. Interactions of Particles with Matter Interactions of Photons Pair Production (Attenuation Length) Along with Bremsstrahlung (more later), pair production is a very important process in the development of EM showers X0is a key parameter in the design of a calorimeter There are more complicate expressions forX0in the literature: (PDG, http://pdg.lbl.gov) Lrad is similar to the expression forX0in the previous slide L’rad replaces 183Z-1/3 by1194Z-2/3 f(z) is an infinite sum which, for elements up to U, can be approximate to Wherea = αZ PDG also gives a fitting function:

31. Interactions of Particles with Matter http://pdg.lbl.gov Interactions of Photons Pair Production For compound mixtures: Where, wj =weight fraction of each element in the compound j = “jth”element

32. Interactions of Particles with Matter Photoeletric effect Energy range versus Z for more likely process: Pair production Rayleigh scattering Interactions of Photons Summary http://pdg.lbl.gov Compton Michele Livan

33. Calorimeters? Curiosity  Primitive calorimeter invented by Benjamin Thompson (17th century): “We owe the invention of this device to an observation made just before the turn of the nineteenth century by the preeminent scientist Benjamin Thompson ( Count Rumford). While supervising the construction of cannons, Rumford noticed that as the fire chamber was bored out, the metal cannons would heat up. He observed that the more work the drill exerted in the boring process, the greater the temperature increase. To measure the amount of heat generated by this process, Count Rumford placed the warm cannon into a tub of water and measured the increase in the water's temperature. In doing so, he simultaneously invented the science of calorimetry and the first primitive calorimeter. In simplest terms, a modern calorimeter is a water-filled insulated chamber. When a hot object is set within the water, the system's temperature increases. By measuring the increase in the calorimeter's temperature, a scientist can calculate such factors as the specific heat (the amount of heat lost per gram) of a substance. Another application of calorimetry is the determination of the calorific value of certain fuels--that is, the amount of energy obtained when fuel is burned. Engineers burn the fuel completely within a calorimeter system and then measure the temperature increase within the device. The amount of heat generated by this burning is indicative of the fuel's calorific value. “ (http://www.bookrags.com/Calorimeter)