Do Now (10/14/13):

1. Do Now (10/14/13): • What is Ohm’s Law? • What do you know about electric circuits? • In your own words, what is electric current?

2. ELECTRICAL CIRCUITS All you need to be an inventor is a good imagination and a pile of junk. -Thomas Edison

3. Review:Ohm’s Law I = V / R I = Current (Amperes) (amps) V = Voltage (Volts) R = Resistance (ohms) Georg Simon Ohm (1787-1854)

4. How you should be thinking about electric circuits: Voltage: what pushes the current through the circuit (in this picture it would be equivalent to gravity)

5. How you should be thinking about electric circuits: Resistance: friction that impedes flow of current through the circuit (rocks in the river)

6. How you should be thinking about electric circuits: Current: the actual “substance” that is flowing through the wires of the circuit (electrons!)

7. Would This Work?

8. Would This Work?

9. Would This Work?

10. The Central Concept: Closed Circuit

11. Series and Parallel Circuits

12. Circuits • Can either be series or parallel.

13. 20.1 Series and Parallel Circuits • In series circuits, current can only take one path. • The amount of current is the same at all points in a series circuit.

14. Series • Current only takes one path for electrons • Current flows through every part of the circuit

15. Lights in a Series

16. Series • If you add a resistor (like another light): • Total resistance goes UP since all the current has must go through each resistor.

17. Adding Resistors to Series: • Current in the circuit will go DOWN (lights will dim) • If you remove a light bulb or one burns out—all go out!

18. Current in Series • Current is the same at all points • Use Ohm’s Law to find current using resistance and voltage

19. Calculating Current Example: • A 6 V battery is connected to

20. Voltage in Series • Voltage is reduced by each resistance – voltage drop

21. Calculating Voltage Example • A 6 V battery is connected to a series circuit. If the current is 2 A, what is the voltage across a 2Ω resistor?

22. Resistance in Series • Add up all resistors to get total • Total resistance will go up because all of the current must go through each resistor.

23. Adding resistances in series • Each resistance in a series circuit adds to the total (or equivalent) resistance of the circuit. Rtotal = R1 + R2 + R3... Total resistance (ohms) Individual resistances

24. Calculating Resistance Example: • A series circuit contains a 12Ω, 10 Ω and 8Ω resistor. What is the equivalent resistance?

26. Circuit Symbols

27. Exit Question: • Draw a series circuit with the following: • A 12 V battery • Two 3Ω resistors • One 5Ω resistor • What is the one variable that will not change throughout the circuit?

28. Do Now (10/15/13): • Draw a series circuit diagram containing the following: • A 2Ω resistor • A 1Ω resistor • A 6V battery • Which variable does not change throughout a series circuit?

30. Light bulbs, resistors, motors, and heaters usually have much greater resistance than wires and batteries. 20.1 Total resistance in a series circuit

31. How much current flows in a circuit with a 1.5-volt battery and three 1 ohm resistances (bulbs) in series? 20.1 Calculate current

33. Each separate resistance creates a voltage drop as the current passes through. As current flows along a series circuit, each type of resistor transforms some of the electrical energy into another form of energy Ohm’s law is used to calculate the voltage drop across each resistor. 20.1 Voltage in a series circuit

34. Sample Problem #1 • Draw a series circuit with two 1.5 V batteries, 3 resistors, and a current of 0.5 A. • What is the total voltage of the circuit? • What is the resistance of each resistor? • What is the voltage drop across each resistor? Label on your circuit.

35. Do Now (10/24/13): • Draw an example of what you a parallel circuit would look like.

36. Extra Credit Opportunity • Open House – Sunday, October 28, 12 – 3 PM • 5 service learning hours! • Free pizza!! • Extra credit!!!

37. Parallel Circuits • Has at least one point where current divides • More than one path for current to flow • Paths are also known as branches

40. Lights in Parallel

41. Parallel: • If you add a resistor: • Total resistance goes down • Total current goes up when you add another path

42. Removing a Light Bulb • If you remove a light bulb or one burns out, the others stay on because the circuit is still closed.

43. Current in Parallel • Current flows into a branching point, the same total current must flow out again • Current depends on resistance in each branch

44. Calculating Current Example:

45. Voltage in Parallel • Voltage is the same across each branch – because each branch is on the same wire

46. Calculating Voltage Example:

47. Resistance in Parallel • Calculate current in each branch based on resistance in each branch by using Ohm’s Law

48. Calculating Resistance Example:

49. Practice problem #2 • Draw a parallel circuit with two resistors (one on each branch) and a 12 V battery. • What is the voltage through each resistor? • What is the current flowing through each branch?

50. Toll Road—Circuit Analogy