1 / 8

Rockets

Rockets. Airframe Assembly. Your Airframe Assembly Needs:. 12” length tube or wood dowel Scissors Wet paper towel 12” ruler 8-1/2 x 11 sheet of paper 29” of 3” wide gummed paper tape Elmers glue Paper towel Drinking straw Pencil/Pen. Airframe Assembly Directions:.

gina
Télécharger la présentation

Rockets

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Rockets Airframe Assembly

  2. Your Airframe Assembly Needs: • 12” length tube or wood dowel • Scissors • Wet paper towel • 12” ruler • 8-1/2 x 11 sheet of paper • 29” of 3” wide gummed paper tape • Elmers glue • Paper towel • Drinking straw • Pencil/Pen

  3. Airframe Assembly Directions: • 1. Cut the 8-1/2 x 11” sheet of paper in 1/2 to make a 4-1/4 x 11” • piece. Wrap this piece tightly around the 1” dia. plastic tube and • apply a narrow bead of glue down the overlapped seam. Make sure • you DO NOT glue the paper to your tube! • 2. Cut off an 11” piece of 3” wide gummed tape. Dampen the sticky • side with a wet paper towel and wrap it lengthwise around the paper • wrapped tube.

  4. 3. With the remaining 18” of the gummed tape, cut the one end off at a • 45 degree angle. • 4. Dampen and wrap the gummed tape around the tube at an angle as shown In the photograph.

  5. 5.Trim the end of your paper airframe • 6. Take the dowel/tube out of your airframe and use it to draw a straight line on your airframe about 7” long off the end. • 7. Cut the drinking straw to 3-1/4 inches long and glue it on • the line 3” off the end. (The top of the straw should be • 6-1/4 of the end of the airframe)

  6. Resources: www.pitsco.com www.estesrockets.com www.NASA.com http://images.google.com/

More Related