1 / 22

Refrigerants and refrigerant oil

Refrigerants and refrigerant oil. The clean air act of 1990. The Environmental Protection Agency [EPA] enforces regulations set in place by the clean air act governing the repair and service of automotive air conditioning systems.

hide
Télécharger la présentation

Refrigerants and refrigerant oil

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Refrigerants and refrigerant oil

  2. The clean air act of 1990 • The Environmental Protection Agency [EPA] enforces regulations set in place by the clean air act governing the repair and service of automotive air conditioning systems. • Fines and prison terms have been imposed on technicians who have violated EPA rules on vent refrigerants into the atmosphere. • The EPA monetarily rewards whistle blowers for information leading to prosecution of violators.

  3. Technician certification • EPA section 609 states: All persons repairing or servicing motor vehicle air-conditioning (MVAC) systems for consideration [being paid for it] must be properly trained and certified by a program authorized by EPA. • Refrigerant handlers certification is done through ASE, MACS [Mobile Air Conditioning Society] and other institution • Currently certification is required for the purchase of R-12 but not for R-134a

  4. Refrigerant properties • A good refrigerant needs to be: • Low boiling point – well below 0 deg. F at atmospheric pressure • High boiling point at pressures above 200 psi • Non toxic • Non flammable • Compatibility with refrigerant oil • Must be compatible with the rubber hoses and seals usedin the A/C system • Have little or no effect on the environment • Inexpensive

  5. Refrigerant properties • Ammonia is often used as a commercial refrigerant but cannot be used in automobiles due to it’s high toxicity. • The ammonia we see in household cleaners is extremely dilute – about 1% by volume. • Inhaling the fumes from concentrated ammonia can be fatal. • Propane is an excellent refrigerant, but imagine what would happen if you were in a front end collision in a car that used propane as a refrigerant.

  6. Chlorofluorocarbons - CFCs • Automotive air conditioning systems installed on cars built before 1990 used refrigerant compounds made from: • Chlorine • Fluorine • Carbon • Hydrogen • Chemicals containing these elements are known as CFCs • R-12 was used on most cars prior to 1993. • R-12 is dichlorodifluoromethane [CCL2F2] • R-12 was marketed by DuPont under the trade name ‘Freon’

  7. CFCs and the environment • In the 1980s it was determined that CFCs that were released into the atmosphere were destroying the ozone layer. • Ozone is a form of oxygen [O3] that is present in the upper stratosphere at 20 to 30 miles above the earth’s surface. • The ozone layer absorbs UV [ultra violet] radiation. • UV radiation in small doses causes sunburn and skin cancer. • If the ozone layer was to be totally destroyed all land base life on earth would be at risk.

  8. CFCs and the environment • Research in the 1980s revealed that it was the chlorine in CFCs that was damaging the ozone layer. • As a result of the Montreal protocol of 1990 CFCs were phased out and replaced by HFCs [Hydrogen-fluorine-carbon] . • The EPA at this time implemented rules requiring reclamation and recycling of refrigerants and began requiring the technicians who service auto A/C systems to be licensed in refrigerant recovery and handling.

  9. R-12 • R-12 was used on all automotive A/C systems on vehicles built prior to 1990. • The world wide production of R-12 has been banned but bootleg R-12 from Asia is still widely available. • Recycled R-12 is also widely available • Only licensed A/C technicians can purchase R-12 • R-12 is the best option for keeping the A/C system in an older car running. • R-12 boils at -21 deg F. • At 30 psi R-12 boils at 32 deg F.

  10. R-134a • R-134a replace R-12 in the early 1990s. • It contains no chlorine so it will not harm the ozone layer but it is also a greenhouse gas. • The SAE is currently evaluating possible replacements for RE-134a but the auto industry has not yet made a decision on what it will be. • R-134a boils at -26 deg F when exposed to atmospheric pressure. • At 27 psi R-134a will boil at 32 deg F.

  11. Retrofits • In the late 1990s the cost of R-12 skyrocketed to over $30 a pound. • Most vehicles built for R-12 were retrofitted to use R-134a or alternatives when their A/C systems needed service. • Retrofitting to R-134a involved changing the service fittings and adding POE refrigerant oil that was compatible with the new refrigerant. • A retrofit label that lists the type of refrigerant should have been installed at the time of retrofit.

  12. Blended refrigerant • Some refrigerants are a mix of two or more chemicals. • Since two chemicals have two different boiling points as refrigerant is lost slowly over time the chemical with the higher boiling point is lost at a faster rate. • Blends were commonly used in retrofits in the 1900s and early 2000s. • R-22 is a blend that was used in stationary A/C systems and sometimes found in some retrofit systems. It is not compatible with the rubber used in most automotive A/C systems and should never be used as an automotive refrigerant.

  13. Future refrigerants • Two refrigerants that are often mentioned as possible replacements for R-134a are: • R-152a • CO2 [Carbon Dioxide] • R-152a has all the properties of an excellent refrigerant except that it is toxic • The system would have to locate the evaporator outside the cabin to utilize R-152a • CO2 is an excellent refrigerant but needs to be compressed to very high pressures [over 700 psi]

  14. Refrigerant containers • Refrigerant is sold in 30 lbs. disposable tanks and 12 oz. cans. • Refrigerant tanks are color coded. • R-12 is white • R-134a is light blue • Refrigerant tanks for R-12 have a 7/16” x 20 conventional threaded fitting for hose attachment. • Refrigerant tanks for R-134a have a ½” x 16 Acme thread fitting for the hose connection.

  15. Refrigerant oil • The bearings and rings in the compressor and the expansion valve require a continuous supply of lubrication oil. • A few ounces of oil circulate with the refrigerant and keep all of the mechanical components well lubricated. • The oil must have a low viscosity to prevent it from turning into wax and blocking the orifice/expansion valve where temperatures will be around 32 deg. F.

  16. Mineral oil • R-12 systems used a mineral oil type lubricant. • Mineral cannot be used in R-134a systems • It will congeal at the bottom of the condenser and evaporator blocking the flow of refrigerant. • Normally light yellow color • Available in 500 or 525 viscosity • Slightly hygroscopic – like brake fluid it absorbs water

  17. PAG • Polyalkylene glycol • Synthetic oil chemically similar to antifreeze • Developed for R-134a systems • Light blue color • Available in 3 viscosities 46, 100 and 150 • Most late model cars that use Asian compress require PAG 46 • Older domestic compressors normally require PAG 150 • Highly hygroscopic – avoid skin contact

  18. Ester - POE • Polyol Ester [POE] is compatible with both R-12 and R-134a so it was used in most retrofits • Clear color – no tint • Slightly hygroscopic • Although it is marketed as a universal oil it should not be used in R-134a systems as PAG is a much better lubricant

  19. A/C system placard • By law new vehicle must have an A/C system placard under the hood that lists: • The type of refrigerant used • The volume of refrigerant needed to fully charge the system • Normally the type and amount of refrigerant oil is also displayed • The placard color for R-134a systems should be gold and yellow

  20. Refrigerant identification • When servicing new cars the type of refrigerant is stated on the A/C system placard under the hood. • When working on and older car the refrigerant listed on the placard may not be what was originally used when the car was built. • Refrigerant identifier machines are available that can chemically analyze the refrigerant currently in the system so that proper recovery can be done.

  21. Desiccants • Desiccants are chemicals that absorb moisture. • A porous bag of desiccant material is installed inside the accumulator or receiver drier to absorb any moisture that may find it’s way into the system. • Water in the system can freeze and block the orifice so that no cooling occurs. • Water also reacts with refrigerant to form acid that corrodes metal parts. • The receiver/drier or accumulator are normally replaced anytime a component is replaced in the system.

  22. UV leak detector dyes • The source of small A/C system leaks are normally detected by adding a dye to the refrigerant and inspecting the system using a UV light source. • The dye glows yellow/green when illuminated by UV light. • Dye can be introduce into the system with a small can of refrigerant mixed with dye, adding liquid dye concentrate to the refrigerant during a recharge or with a special syringe.

More Related