1 / 7

DOC. NO. CH035

Concrete surface was degreased with 803 Degreaser . DOC. NO. CH035. Concrete surface was shotblast to remove contaminants & provide profile . CH035. If additional slides are needed for photos, select slide 2 in Slide Sorter View and press Ctrl-D.

jewell
Télécharger la présentation

DOC. NO. CH035

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Concrete surface was degreased with 803 Degreaser DOC. NO. CH035

  2. Concrete surface was shotblast to remove contaminants & provide profile CH035

  3. If additional slides are needed for photos, select slide 2 in Slide Sorter View and press Ctrl-D. Control joints were cut back and repaired with 3500 Grout CH035

  4. If additional slides are needed for photos, select slide 2 in Slide Sorter View and press Ctrl-D. 3100 was then slurry applied over entire floor & seeded with Part D silica. CH035

  5. 3100 Part D was broadcast and allowed to cure. Excess Part D was then swept up. CH035

  6. 1000 CS was applied over entire surface at 15 mils. 1000 CS was applied in Gray and Safety Green. CH035

  7. 1000 CS Safety Yellow was applied to outline work spaces and aisle ways. CH035

More Related