1 / 6

BAT SIMULATOR

BAT SIMULATOR. J. L. Errington. BAT SIMULATOR. To mimic a bat sound we need to have an ultrasonic output sound. This circuit gives a signal with a frequency of 45 KHz or 90 KHz repeating at a frequency of 8 Hz.

keaton
Télécharger la présentation

BAT SIMULATOR

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. BAT SIMULATOR J. L. Errington

  2. BAT SIMULATOR To mimic a bat sound we need to have an ultrasonic output sound. This circuit gives a signal with a frequency of 45 KHz or 90 KHz repeating at a frequency of 8 Hz. The bat simulator used two NE555 timers. The component used for the practical circuit is a dual NE 555 – called an NE 556. The first stage runs at 8Hz and controls the second stage that operates at 45kHz or 90 kHz The sound is produced by an ultrasonic piezo- transmitter

  3. Circuit diagram for bat simulator 9V 9V 1 14 2.2mF 1nF 2 NE556 13 3 12 4 11 39K Piezo sounder 5 10 16K 16K 6 9 7 8 45 or 90KHz 8 Hz F = 1.44 / 2 R C Here R = 16 K or 8K, C = 1nF Hence F = 45KHz or 90KHz F = 1.44 / 2 R C Here R = 39K, C = 2.2mF Hence F = 8Hz

  4. Circuit operation • The high frequency part (LHS of the diagram, pins 1 – 7) is controlled by the 1nF capacitor and 16K resistors. • The low frequency part (RHS pins 8 – 14) controls the “burst rate”. • The piezo sounder is driven very hard with a square wave and produces harmonics at 2, 3, 4 .. times the chosen frequency.

  5. Tested and working • The circuit is built on veroboard and in a metal box to prevent electrical interference. • A 10k resistor and LED have been added across the circuit to show when its switched on, and a switch in series with the battery to turn power on and off.

  6. FURTHER DEVELOPMENT The 1nF Cap could be increased to 4.7nF A 47K pot +4.7k series resistor would allow signals from about 8kHz to 80kHz (and harmonics to 160kHz) to be generated. A piezo tweeter would need to be used instead of the ultrasonic sender as they are not suitable for work below their fundamental frequency (45kHz.)

More Related