High Mast LightsAnd1000 Watt Led Flood Light High mast lights is a tall pole with lighting attached to the top pointing towards the ground, usually but not always used to light a highway or recreational field. It is utilized at sites requiring lighting over a large area. The pole that the lighting is mounted on is generally at least 30 m (98 ft) tall (under this height it is referred to as conventional lighting system), while the lighting consists of a luminaries ring surrounding the pole with one or numerous independent lighting fixtures mounted around it. Most units have four, six or eight lights in the ring, with three, five, ten, twelve and sixteen lights used in rare instances. While most high-mast lights are high-pressure sodium, other types such as mercury vapor, metal halide as well as LED, have also been utilized. Some units have the lighting surrounded by a circular shield to stop or reduce light pollution or light trespass from affecting neighbourhoods adjacent to the highway. High mast lighting systems may be equipped with dissimilar types of lamps, depending on the preferences and requirements of the project or work site. Previously, high-intensity discharge (HID) luminaries were the standard utilized by companies that required elevated illumination over a wide target area. While effectual, this type of lamp came with several drawbacks that were eventually addressed and rectified through the introduction of light-emitting diodes (LEDs). The promise of clean, energy competent illumination with minimal maintenance has forced some businesses to rethink their lighting technology of choice for industrial towers. Installation cost comparisons between high mast as well as conventional lighting systems vary widely, depending on the application. High Mast Lights for interchanges is commonly less expensive to install than conventional lighting, due to reduced complexity of conduit as well as conductor and the smaller number of fixtures as well as poles required. Outside the interchange, conventional lighting typically requires a smaller initial cost. LED lighting fixtures are made of heat-dissipating aluminum, high-power LEDs as well as LED power supplies are called high-power LED floodlights. They are also called the high-power LED spotlights, high-power LED spotlights and many more as well as are mainly based on diverse applications. Appearance is divided into round or square or long strip, power from 3 watts to 1 kW. 1000 Watt Led Flood Light is mainly utilized for tunnel lighting, outdoor flood lighting, architectural decorative lighting, industrial place lighting, sports centersas well as outdoor stadiums, ports, docks, etc.
The main heat-dissipating component of the lamp is an ultra-high-heat-conducting aluminum material, and the heat-dissipating element is preferably a scale-type or copper- column type or height-increased as well as stable long-life fan. Stable rectification, steady current drive LED power supply, instantaneous drive, power factor above 0.96 make power supply more well-organized, 50,000 hours operation without failure. High-performance integrated 10 watts or more LED or more than 1 watt LED to decrease the cost of the use of integrated LED, focusing on the utilize of multiple light beads.