1 / 1

Live Centers

Storage. Purpose – Live centers are used when a shafts length to diameter ratio is greater than 3:1 in lathe operations. This gives the shaft a second support and minimizes deflection and eccentricity. Location – Live centers should be located in your stations drawer see photo Safety –

ojal
Télécharger la présentation

Live Centers

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Storage Purpose – Live centers are used when a shafts length to diameter ratio is greater than 3:1 in lathe operations. This gives the shaft a second support and minimizes deflection and eccentricity. Location – Live centers should be located in your stations drawer see photo Safety – Live centers should be tightened to work piece while the lathe is running. Also as always keep fingers and loose clothing free of moving parts. • Tips – • The piece to be supported should be center drilled with an appropriate 60 degree center drill. • The live center’s shaft should be inserted as far as possible. This will ensure that the end of the live center will be stable as well. Also, lock the tailstock to the rails and use the spinning handle as the motion of the live center. • With your part in the chuck, start the lathe and slowly insert the live center in the center drill hole. Apply moderate force until the live center is approximately rotating at the same speed as the part • Clean up – • To take live center out of tailstock, turn wheel so that the jaws are fully retracted, remove from tailstock, wipe clean, and replace in drawer where found. • Purchase – • To purchase, call MSC or see MSC Direct > < Live Centers >> << Setup 1 2 3

More Related