1 / 2

Cantilever Beam

After tuning the Delay Time and final set point, the embossing tool was used to heat the resistor in the filter. During heating, the following (worse) result was obtained, further demonstrating the advantages of control over programmatic operation. Cantilever Beam.

olinda
Télécharger la présentation

Cantilever Beam

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. After tuning the Delay Time and final set point, the embossing tool was used to heat the resistor in the filter. During heating, the following (worse) result was obtained, further demonstrating the advantages of control over programmatic operation.

  2. Cantilever Beam The cantilever beam system is a 2nd order system, while the RC filter we are controlling in this lab is a 1st order system. Both of these systems display damped oscillations when presented with step forcing. With the addition of this controller, we create from the first-order filter a more complicated (higher-order) system with a response resembling the 2nd order beam system.

More Related