1 / 11

GWS SMS INTRODUCTION

GWS SMS INTRODUCTION. Health & Safety Manual. 4.3 MANAGEMENT COMMITTEE MEETINGS. Master, Chief Officer, Chief Engineer and 2nd Engineer form the Management Committee. Other officers may be invited to join at Master’s discretion. Frequency: At least one meeting must be held in a month.

rich
Télécharger la présentation

GWS SMS INTRODUCTION

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. GWS SMS INTRODUCTION Health & Safety Manual

  2. 4.3 MANAGEMENT COMMITTEE MEETINGS • Master, Chief Officer, Chief Engineer and 2nd Engineer form the Management Committee. Other officers may be invited to join at Master’s discretion. • Frequency: At least one meeting must be held in a month.

  3. 5.1.2 Health & Safety Guidelines • Permits are established for controlling under mentioned activities: • Enclosed space entry permit F-S-0449 • Hot work permit F-S-0450 A/B/C • Cold work permit F-S-0457 • Electrical isolation permit F-S-0456 • Work on pressure vessels F-S-0458 • Working aloft F-S-0453 • Working over side F-S-0455 • Small crafts alongside F-S-0451 • Work with Asbestos F-S-0459 • Underwater Diver operation F-S-0462

  4. 5.2 HOTWORK PROCEDURES • HOTWORK SHOULD ONLY BE CONSIDERED IF THERE ARE NO PRACTICAL ALTERNATIVE MEANS OF REPAIR. • Planning and Risk Assessment is carried out diligently. • Advising the office regarding the intended hotwork and forwarding the appropriate documents and plan • Issuing hotwork permit. • Ensuring that correct procedures are understood and followed by all concerned

  5. 5.4 Entry Into Enclosed Spaces Control the entry of personnel into an ‘Enclosed Space’ which has: • Limited openings for entry and exit. • Unfavourablenatural ventilation. • Not been designed for continuous worker occupancy. • Enclosed spaces include, but are not limited to, cargo spaces, double bottoms, fuel tanks, ballast tanks, pump rooms, compressor rooms, cofferdams, void spaces, duct keels, inter-barrier spaces, engine crankcases and sewage tanks. • All enclosed spaces must be considered unsafe for entry until proven otherwise.

  6. 5.6 Important Aspects of Electrical Equipment Isolation & Maintenance • The knowledge of how to immediately isolate appropriate circuits. • How to remove a person in contact with a live circuit using rubber gloves and non-conductive ropes or devices. • Knowledge and willingness to initiate Cardio Pulmonary Resuscitation.

  7. 6.1 Personal Protective Equipment

  8. 7.07 Handling Of Chemicals & Liquefied Gases • Material Safety Data Sheets (preferably laminated) should be available near the place where the chemicals are stored and handled. • A copy of all material safety data sheets should be available with the Chief Engineer / Chief Officer. The list shall be reviewed annually to ensure that all relevant sheets for chemicals on board are valid, and being maintained in file, and this should be included in the Master’s Review.

  9. 8.06 Handling Asbestos • Company recognises the occupational health hazards associated with asbestos and does not allow the use of asbestos on board. • Additionally, Please refer to form F-S-0459.

  10. 9.01 Helicopter Operations • Please refer to checklist:- F-S-0463 Helicopter Operations Checklist

More Related