1 / 8

Network Anatomy

Learn how to wire fixed Ethernet cables using the T568A and T568B wiring standards. Follow the step-by-step guide to strip, untwist, align, trim, insert, and crimp the cables correctly. Ensure your network devices are connected properly!

cmarion
Télécharger la présentation

Network Anatomy

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Network Anatomy By: Roland J. Boutte

  2. Ethernet Cable • cable used to connect computing devices together directly. • two hosts or two switches to each other such as a network switch, hub, or router.

  3. Straight-Through Ethernet Cable Pin Out for T568A Standard, Straight-Through Wiring Diagram (both ends are the same):

  4. Straight-Through Ethernet Cable Pin Out for T568B

  5. How to wire fixed Ethernet Cables:Steps #1-2 • Strip off about 2 inches of the Ethernet cable sheath. • Untwist the pairs - don't untwist them beyond what you have exposed, the more untwisted cable you have the worse the problems you can run into.

  6. Steps #3-4 • Align the colored wires according to the wiring diagrams above. • Trim all the wires to the same length, about 1/2" to 3/4" left exposed from the sheath.

  7. Steps #5-6 • Insert the wires into the RJ45 plug - make sure each wire is fully inserted to the front of the RJ45 plug and in the correct order. The sheath of the Ethernet cable should extend into the plug by about 1/2" and will be held in place by the crimp. • Repeat the above steps for the second RJ45 plug.

  8. Steps #7-10 • Crimp the RJ45 plug with the crimper tool. • Verify the wires ended up the right order and that the wires extend to the front of the RJ45 plug and make good contact with the metal contacts in the RJ45 plug • Cut the Ethernet cable to length - make sure it is more than long enough for your needs. • Repeat the above steps for the second RJ45 plug.

More Related