1 / 19

DC Motor Control Project

DC Motor Control Project. Group A ALEXANDER M FUNK LAM D NGUYEN JAKEISHA D THOMPSON PAULETTE J VERNON ERIC G ZAISER 12/03/01. Introduction. Motor Design Motor Construction Problems Control Design Control Problems Final Results Conclusion. Project Overview.

declan
Télécharger la présentation

DC Motor Control Project

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. DC Motor Control Project Group A ALEXANDER M FUNK LAM D NGUYEN JAKEISHA D THOMPSON PAULETTE J VERNON ERIC G ZAISER 12/03/01

  2. Introduction • Motor Design • Motor Construction Problems • Control Design • Control Problems • Final Results • Conclusion

  3. Project Overview • Design, construct, and control a dc homemade motor, commutation system, control system, and a speed measurement device such that the machine assembly rotates at selected speeds • Create a detailed web-page to outline the development process

  4. Specifications • The outer diameter of the rotor: 1.5 and 4.5 inches. • The length of the rotor housing: 2 and 6 inches. • A commutator must be built. • Standard magnets must be used • Supply jacks must be supplied for an unknown resistance

  5. Schedule

  6. Motor Design • Four Pole Motor • Simplex Lap Winding • 45 windings • 26 gauge Copper Wire • Steel Stator – 3.5“ inner diameter and 4” outer diameter • 16 magnets(1” by ½“ by ¼“) acting as 4 poles • JB Weld to place magnets • Steel rotor-2” diameter • 25 1/8” thick, 2.5” outer diameter discs; 12-0.35” diameter holes

  7. Motor Design • 4 brushes alternating at 90° • 3/8” Shaft • Polyurethane lamination

  8. DC Permanent Magnet Motor

  9. 4 Pole Simplex Lap Winding

  10. Commutator • 1.5 inch inner diameter copper pipe • 12 segments required for four pole operation • Vinyl insulation from the shaft • Brush contact • 12 segments (2 x 0.78 inches ) • Epoxy to fill in slots

  11. Motor Construction Problems • Uneven commutator bars • Drilling through copper for hooks • Commutator bars popping off • Misalignment of magnets in the stator • Fitting the bearings onto the shaft • Sliding of shaft as motor was spinning • Friction in commutator from lack of epoxy

  12. The Final Product

  13. Control Basic • Hardware Setup • Initial Research Regarding Motors • Limited Theoretical Modeling • “Control Theory” group shifted to “Test & Fix” Group

  14. Encoder Open Loop/Bonus day PID implementation Tweaking/Tuning Competition Control Implementation

  15. Control System in Simulink

  16. Control Problems • Encoder-related • Mounting • Cable • Motor-related • Friction • Drift/alignment • Simulink-related • Disappearing feedback

  17. Final Results • Bonus Day :300 rpm 10 points • Competition Day: 1st Place • Average Steady State Error of +/- 5.33 RPM • Transient score of .4165

  18. Transient Response

  19. Conclusion • Motor design was outstanding • Steady state control was outstanding • Control system was outstanding Group A is Great!!

More Related