1 / 3

TE-MPE-EP : Activities during TS3

TE-MPE-EP : Activities during TS3. TE-MPE-EP, RD, 13-Sept-2012. List of interventions:. Reset of all DAQ systems, which recorded SEU events (all sectors).

jontae
Télécharger la présentation

TE-MPE-EP : Activities during TS3

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. TE-MPE-EP : Activitiesduring TS3 TE-MPE-EP, RD, 13-Sept-2012

  2. List of interventions: • Reset of all DAQ systems, which recorded SEU events (all sectors). • With EE: Test of the new instrumentation wiring for transmission of QPS signals for the protection of Q10.L2. Powering tests required (above stand-by current) and is only permitted after analysis of the magnet signals by experts. It is strongly recommended to perform the powering tests on either Monday or Tuesday. • Pilot upgrade of radiation tolerant digital quench detectors of type nDQQDI. The selected circuit is RQ6.R1 (protection systems installed in RR17; requires powering tests). During the powering test a QPS specialist must be present. Due to limited expert availability this test must take place on either Monday or Tuesday. • New detection settings for current lead protection systems type DQQDC (threshold of 1 mV, 1s evaluation time). The selected circuit is RB.A12 but only the two detectors in the even point (UA23) will be upgraded (requires powering tests). • Firmware upgrades for some 600 A protection units DQGPU type A (DQGPU.C=RR77 and DQGPU.I=RR57); verification of a remote power cycling unit in RR57. • Access to CNRAD test area on Thursday morning from 9:00 am to 12:00 pm: reset and insertion of a power cycling unit. TE-MPE-EP, RD, 13-Sept-2012 If powering tests cannot be performed all upgrades described in 2, 3 and 4 will be rolled back to the original configuration.

  3. List of interventions: 7) BIS and SMP systems: • Preparation and cabling of the installation of a BIC in the BOOSTER related to LINAC4 tests. • With « timing people » : plan theyprovide a signal in order to verifythat the Cross Checker (CISC) istriggering the beam. • Reprogramming of receiverboards CISR (monitoring side). • To get back 2 unused couples of CIBF from IR4. • If possible: exchange the faulty CISV from Alice experiment. TE-MPE-EP, RD, 13-Sept-2012

More Related