1 / 6

The Extinguisher Special Sensor Presentation Hamamatsu UVTron Flame Detector

The Extinguisher Special Sensor Presentation Hamamatsu UVTron Flame Detector. By: John Miller III Drs. Arroyo & Schwartz. The Sensor. ● Looks like a light bulb ● Operates at 350VDC ● Operates in the spectral range of 185 to 160nm ● Has two leads, anode and cathode

mervyn
Télécharger la présentation

The Extinguisher Special Sensor Presentation Hamamatsu UVTron Flame Detector

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. The Extinguisher Special Sensor PresentationHamamatsu UVTron Flame Detector By: John Miller III Drs. Arroyo & Schwartz

  2. The Sensor ● Looks like a light bulb ● Operates at 350VDC ● Operates in the spectral range of 185 to 160nm ● Has two leads, anode and cathode ● Surges current when it detects flames

  3. The Driver Board ● A good engineer is a lazy one, so I bought the driver board! ● Requires 5VDC input ● It has three different outputs ● I am using the open collector output, mainly so that I can test with an LED

  4. The Test Circuit ● Consists of a 3A 5VDC regulator, a low ESR 10uF capacitor, a 1uF cap, a 10k resistor, an LED, the UVTron sensor, the driver board, a lithium ion battery, my Atmega128 PCB, and a breadboard

  5. Some Problems…. ● Needed to increase pulse width of driver board output so that I could detect with Atmel (and visually on LED) with a polling routine. I could just as easy use an EIRQ to detect, but I could still not see a 10ms blink on LED ● Output originally 10ms, with 1uF cap I increased it to ~1second. ● Needed VERY stable 5V, so I added low ESR cap to input of regulator to increase noise performance ● Sensor works too good, which leads me to my next slide…………………..

  6. The Cone filter ● I want to see a flame directly in front of the sensor so that my tank will know where the flame is exactly ● With paper (I will use more sophisticated materials on final design) I created a cone to place over sensor ● With cone I still had incorrect readings (due to reflection of waves) ● I determined that it will need a very small opening, and that it must be very circular in form to not have wave reflection (I looked this up online on physics sites) ● It works!!!!! Detects only when within ~5 degrees of opening ● I have a temperature sensor to work in conjunction with this to detect location more exactly

More Related