1 / 35

Milwaukee Electric Tool Slider-Crank Analysis and test

Khaled Alaassmi and Majid Al Qutaim. Milwaukee Electric Tool Slider-Crank Analysis and test. Project Goal. The goal of the project is to determine the offset that provides the best cutting performance for M-18 Sawzall . . Cutting Geometry A=12.2mm= 0.4803 in

zea
Télécharger la présentation

Milwaukee Electric Tool Slider-Crank Analysis and test

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. KhaledAlaassmi and Majid Al Qutaim Milwaukee Electric Tool Slider-Crank Analysis and test

  2. Project Goal • The goal of the project is to determine the offset that provides the best cutting performance for M-18 Sawzall.

  3. Cutting Geometry A=12.2mm= 0.4803 in B= 56.9 mm= 2.24 in C= 19.812 = 0.78 in Pin A C = Offset B XOut C A Angle = z Drive Gear Direction of Rotation

  4. Displacement Analysis of Offset Slider Crank Mechanism Using a Vector Loop Closure Equation:O2A = O2D + DB + BA b c a D

  5. Velocity Analysis Equations

  6. Acceleration Analysis Equations:

  7. Analysis using the “Linkages” software from Robert L. Norton, Design of Machinery, 5ed

  8. Analysis using linkages software • Linkage software was used to make the analysis at 3 different offsets • Offset of 0.78 in • Offset of 0 in • Offset of -0.78 in

  9. Analysis Using Linkages Software • At an offset of C=0.78 in

  10. Analysis Using Linkages Software • At an offset of C=0 in

  11. Analysis Using Linkages Software • At an offset of C = -0.78 in

  12. Designing Slider Crank Using Pro-Engineer Wildfire 5

  13. Pro E Analysis • At offset of C= 0.78 ”

  14. Pro E analysis • At offset of C= 0 ”

  15. Pro E analysis • At offset of C= -0.78 ”

  16. Physical Testing

  17. Physical Testing 2 different offsets 10 runs each offset At an offset of 0.78 in and 0 in The average cutting time for each offset was calculated Test was performed on 2 x 4” wood. The applied load on the blade was 7.4 lb

  18. Physical testing Cutting performance = Time required to cut through 2x4 pine board At C = 0 in, Tavg = 8.9 s, sd= 1.4 At C = 0.78 in, Tavg = 6.3 s, sd= 0.3

  19. Recommendation • Use the Prototype Fixture to Design a Metal Fixture.

  20. Acknowledgements • Roger Neitzell • Milwaukee Electric Tool Corporation

  21. Questions ?

More Related