1 / 9

Hot Stick Voltage Tester

Hot Stick Voltage Tester. Model 4E2-1 1500 Volt Model. Voltage Tester .

Pat_Xavi
Télécharger la présentation

Hot Stick Voltage Tester

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Hot Stick Voltage Tester Model 4E2-1 1500 Volt Model

  2. Voltage Tester • The model 4E2-1 voltage tester is especially designed to detect electrical potential between the third rail and ground rail on high voltage electrified transit system. For this application housing itself, including its hand-grip and the prod which is applied to the third rail, has a length of twenty inches.

  3. Voltage Tester • The tester can be used on either AC or DC over a wide range of voltage up to 1500 volts. A dual neon lamp principle provides double safety protection to the operator- two independent circuits indicate the presence of voltage. Another safety feature is the limitation of current through the test circuit to less then 3 mill amperes at 1500 volts

  4. Voltage Tester • The neon indicating lamps are mounted in special shielded cavities with in the instrument housing so that the neon glow indication can be unmistakably seen ever under the most adverse conditions of bright, direct sunlight on the instrument during tests. • The prod handle and the tester housing, with rubber hand guard, are made of moisture-and oil resistant laminated phenolic. There are no exposed metal parts other than the two stainless-steel prod tips.

  5. Operating Instruction For the Voltage Tester Model 4E2-1 Note-Always test on a known live circuit prior to each use. 1. Grasp large probe handle immediately behind the rubber hand guard ring located approximately 4-1/2” from the rear end handle. Hold handle so that neon bulbs can be seen through viewing ports in handle.

  6. Operating Instruction 2. Grasp small probe handle immediately in front of rubber boot located at the rear end of the handle.

  7. Operating Instruction 3. Move small handle so as to make contact between the small probe tip and ground

  8. Operating Instruction 4. Move large handle so as to make contact between the metal probe and the high voltage line. 5. Observe neon bulbs. If lit, the circuit is energized 6. NEVER TOUCH METAL PROD TIPS DURING USE OF THE TESTER.

  9. Where to Get More Information • KNOPP INC. 1307 66TH STREET EMERYVILLE, CA 94608

More Related