1 / 2

Initial Design for Canoe Balls and Grooves on Wrist

Initial Design for Canoe Balls and Grooves on Wrist. Interface plates have negative features to contact surface (ie. arm plate has wrist features) Plates are 30mm thick One bolt of two used to secure plate while other bolt is longer to secure assembly

Rita
Télécharger la présentation

Initial Design for Canoe Balls and Grooves on Wrist

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Initial Design for Canoe Balls and Grooves on Wrist • Interface plates have negative features to contact surface (ie. arm plate has wrist features) • Plates are 30mm thick • One bolt of two used to secure plate while other bolt is longer to secure assembly • Tabs added to outside to hold large balls and grooves • Design only prototype to use large items, later will have smaller size to fit in wrist area with plates in kit or without plates for permanent use • Preload by separate bolts Grey – Robot Arm Orange – Arm Interface Plate Green – Canoe Balls Blue – Grooves Red – Wrist Interface Plate Yellow – Preload Bolts Not Shown - Wrist

  2. Exploded View of Assembly Short dashes show explosion of grooves and balls Long dashes show bolts to fix arm interface plate to arm Couplingcenter is 20mm higher than centerofwrist and arm interface Yellow preload bolts pass through arm interface plate, canoe balls, and grooves. Bolts thread into holes on wrist plate.

More Related