1 / 13

Isograds for a single shale unit in southern Vermont

Isograds for a single shale unit in southern Vermont Which side reflects a higher grade, or higher P/T environment?. Systems. Rock made of different minerals Metamorphic agents of change beat on it  metamorphic reactions occur A closed system does not gain or lose material of any kind

chantale-perry
Télécharger la présentation

Isograds for a single shale unit in southern Vermont

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Isograds for a single shale unit in southern Vermont • Which side reflects a higher grade, or higher P/T environment?

  2. Systems • Rock made of different minerals • Metamorphic agents of change beat on it  metamorphic reactions occur • A closed system does not gain or lose material of any kind • An open system can lose stuff – liquids, gases especially Outside world Hunk o’ rock

  3. Phase diagrams • Tool for ‘seeing’ phase transitions • H2Oice H2Oliquid • Reaction (line) governed by DG=DH – TDS • Phase Rule: • P+F=C+2 • Phases coexisting + degrees of freedom = number of components + 2 • Degree of freedom  2= either axis can change and the phase stays the same  where??

  4. Phase diagrams • Let’s think about what happens to water as conditions change… • P+F=C+2 • Point A? • Point B? • Point C? A B C

  5. Mineral Assemblages in Metamorphic Rocks • Equilibrium Mineral Assemblages • At equilibrium, the mineralogy (and the composition of each mineral) is determined by T, P, and X • Relict minerals or later alteration products are thereby excluded from consideration unless specifically stated

  6. The Phase Rule in Metamorphic Systems • Phase rule, as applied to systems at equilibrium: F = C - P + 2 the phase rule P is the number of phases in the system C is the number of components: the minimum number of chemical constituents required to specify every phase in the system F is the number of degrees of freedom: the number of independently variable intensive parameters of state (such as temperature, pressure, the composition of each phase, etc.)

  7. The Phase Rule in Metamorphic Systems C = 1 (Al2SiO5) • F = 1 common • F = 2 rare • F = 3 only at the specific P-T conditions of the invariant point (~ 0.37 GPa and 500oC) Consider the following three scenarios: Figure 21-9. The P-T phase diagram for the system Al2SiO5 calculated using the program TWQ (Berman, 1988, 1990, 1991). Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.

  8. Representing Mineral Reactions • albite  jadeite + quartz

  9. From Hacker, B.R.,

  10. Let’s put it all together…

  11. Metamorphic facies • P-T conditions, presence of fluids induces different metamorphic mineral assemblages (governed by thermodynamics/ kinetics) • These assemblages are lumped into metamorphic facies (or grades)

  12. What if we had staurolite and andalusite together? What conditions would that indicate?

More Related