1. Use Visual Signaling Techniques

2. Sub Task

3. Equipment Listing

5. Administrative Data Cell phones/pagers Risk assessment (low) Environmental conditions (none) Safety requirements (none)

6. Terminal Learning Objective Task: Use Visual Signaling Techniques 071-326-0608 Conditions: Given a requirement to use visual signals while mounted. Standards: Give the proper procedures for each required action.

7. Performance Steps 1. Ensure the Soldiers you are signaling can see you. 2.Perform the visual signals for combat formations, battle drills, and movement techniques as follows: a. Perform formation signals coil and herringbone:

10. Performance Steps (cont.) b. Contact left, contact right, action right, action left, action front (right, left, or rear), air attack, and nuclear, biological, or chemical attack:

16. Performance Steps (cont.) c. Perform the following movement technique signals: 1.Traveling 2.Traveling Over-watch 3. Bounding Over-watch

20. Performance Steps (cont.) d. Perform Vehicle Signals. Move to the left Move to the right Move forward Attention I am ready / ready to move. Mount Disregard previous command. I do not understand

29. Performance Steps (cont.) d. Perform Vehicle Signals. (cont.) 9. Start engine / prepare to move 10. Halt / stop 11. Increase speed 12. Advance 13. Open up / close up 14. (make a) right or left turn 15. Slow down 16. Move in reverse

39. Performance Steps (cont.) d. Perform Vehicle Signals. (cont.) 17. Close distance between vehicles and stop 18. Stop engines 19. Dismount 20. Neutral steer 21. Stop 22. Button up / unbutton 23. Message Acknowledged

47. Performance Steps (cont.) 3. Perform Flag Signals Single signal flag Mount Dismount Dismount & Assault Assemble / Close Move Out Nuclear, Biological or Chemical Hazard Present.

56. CHECK ON LEARNING

57. CHECK ON LEARNING

58. Performance Measures(cont.) Evaluation Preparation: SETUP: At the test site, provide a set of vehicle-signaling flags and flashlight. From the signals shown in the task, pick 10 to test.BRIEF SOLDIER: Tell the Soldier you will give the ten signals, and he must correctly execute each one Evaluation Preparation: SETUP: At the test site, provide a set of vehicle-signaling flags and flashlight. From the signals shown in the task, pick 10 to test.