1. What is Netgear Router Error Code 651? Netgear Router error code 651 usually occurs due to a faulty network connection. This complication usually happens when-1- The modem or other connecting services report an error.2- Wrong registry files affect the function of the router.3- Miniature drive port files ‘Raspppoe. Sys’ are mediators that connect the hardware to the device. If those files are saved in the wrong place, such error will appear.4- If you are using the wrong IP address for the site, then this problem will come up.

2. How to Resolve Netgear Router Error 651? Primarily it is important to reset the Windows networking stack to resolve Netgear Router error 651. Enter a command prompt and copy it on the clipboard. Click the Enter button and restart your laptop. You can recreate the connection lines by clicking on the 'broadband connection.'

3. Step - 1 Reconnect Your Router or Other Connecting Device This is the most basic troubleshooting step, and everyone can simply solve this error by just reconnecting the internet connecting device. So if you are using a router then simply turn off your router and after 5 minutes, turn it on or if you are using LAN connection then unplug the wire and plug it back.

4. Step - 2 Reset TCP/IP On Your PC. You should try resetting the Windows networking stack can solve error 651 and luckily windows 8/7/Vista comes with a built-in tool you can use. Follow the below steps to do this thing:- • First, launch a command prompt with the administrative right. • Then copy the command “Netsh int IP reset reset.log ”. • Then press “Enter” key. • Restart your computer.

5. Step - 3 Recreating Dial-Up Connection Might be your internet connecting device get hanged during the connection. So the best solution to fix the issue is to recreate your dial-up connection. Then simply right click your “Dial-Up” or “Broad band connection” and then choose “create a copy” and then delete your existing connection.

6. Step - 4 Boot the Computer in Safe mode. Disable Antivirus software. It is suggested by the Netgear Router tech support team to boot the computer in safe mode with the networking and check if you are able to connect to the internet without any issues, safe mode starts Windows with a limited set of files and drivers. Startup programs don’t run in safe mode, and only the basic drivers needed to start Windows are installed.

7. Step - 5 Perform Clean Boot • Go to start and search for “msconfig.exe”. • Click it to launch windows configuration. • Now under general tab click on “Selective startup: and select Load startup items. • Now switch to “Services” tab and check “Hide all Microsoft services”. • After that, you just need to click on “Disable” all to disable all other services. • Now simply just restart your PC to perform a clean boot.