1 / 10

Fly Spy – Group 12 Reliability and Safety Analysis

Fly Spy – Group 12 Reliability and Safety Analysis. Heather Barrett. Definition of Criticality Levels (In-flight operation). High : Plane crashes (goes out in a blaze of glory) or cannot be returned to manual control (flies off into the “Wild Blue Yonder”)

dolan-wolfe
Télécharger la présentation

Fly Spy – Group 12 Reliability and Safety Analysis

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Fly Spy – Group 12Reliability and Safety Analysis Heather Barrett

  2. Definition of Criticality Levels(In-flight operation) • High : Plane crashes (goes out in a blaze of glory) or cannot be returned to manual control (flies off into the “Wild Blue Yonder”) • Medium : Loss of autonomous control functionality; Must return to manual control • Low : Some loss of non-critical functionality (ex. Cannot take pictures)

  3. Components Chosen for Analysis • Few components are complex or run hot • Microcontroller (PIC24FJ256GA110): Most complex component • Mux (P13V512): Operation is essential; controls switching between manual and autonomous modes • Buck Converter (LTC1174) : Operation is essential; everything (including micro and mux) is powered on the +3.3 V rail

  4. FMECA – Microcontroller

  5. Control Mode Switching System

  6. Control Mode Switching System

  7. FMECA – Control Mode Switching System

  8. Power Supply

  9. FMECA – Power Supply

  10. Additional Remarks • Due to software complexity, most of these hardware failures appear trivial concerns • In retrospect, should have powered mux on +5 V rail like the servos and motor; if +3.3V source fails, mux fails (no signal to servos  CRASH)

More Related