1 / 6

Opto-Board Update

Opto-Board Update. D. Shane Smith K.K. Gan. Preferred Connector Identified. Samtec LSHM series Right angle SMD Allows thick film design on only one side of BeO No vias through BeO for cost saving Hermaphroditic connector Fits within minimum envelope determined by fiber connectors

gomer
Télécharger la présentation

Opto-Board Update

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Opto-Board Update D. Shane Smith K.K. Gan

  2. Preferred Connector Identified • Samtec LSHM series • Right angle SMD • Allows thick film design on only one side of BeO • No vias through BeOfor cost saving • Hermaphroditic connector • Fits within minimum envelope determined by fiber connectors • D-Board – use 80 pin version • B-Board – use 100 pin version

  3. Minimum D-Board Envelope with LSHM Connector 30 mm 9 mm 29 mm

  4. Opto-board Connected to Motherboard with LSHMs

  5. Elbow Room • 29mm makes design tight between DORIC / VDC and board edge • Need to know maximum width allowed for both B and D boards to make this a little easier 29 mm

  6. Schedule / Plan • Starting on layout now • Sample connectors on order for final selection • Any objections to connector choice? • Layout should be completed by Dec. 16

More Related