1 / 43

Radio Access

Radio Access. Johan Montelius jm@ sics .se. Shannon. C = W x log 2 (1 + S/N). The capacity [C] in bits/s is directly proportional to the available bandwidth [W] and log 2 proportional to the signal to noise ratio [S/N]. bandwidth & power. Attenuation in open space.

hall
Télécharger la présentation

Radio Access

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Radio Access Johan Monteliusjm@sics.se

  2. Shannon C = W x log2(1 + S/N) The capacity [C] in bits/s is directly proportional to the available bandwidth [W] and log2 proportional to the signal to noise ratio [S/N].

  3. bandwidth & power

  4. Attenuation in open space Sr = S0/4r2 The signal strength at a distance [Sr] is directly proportional to the sending strength [S0] and indirectly proportional to square of the distance [r]

  5. Real life In urban environment the signal strength is proportional to 1/rk where k = 1,6 … 3,8

  6. Distance costs

  7. Too bad for broadcast but good for cellular systems Not a problem detectable good quality

  8. What is interference

  9. Rules of thumb • Bandwidth • most important factor to increase capacity • Power • will buy you distance but at a high cost • Noise • your own signal can be the worst problem

  10. Divide the resources • Space • systems ”far” apart don’t interfere with each other • Frequency • modulate the signal to use a specified frequency band • Time • synchronize and allocate time slots • Code • Information coding

  11. 1800 1850 1900 1950 2000 2050 2100 2150 2200 2250 National/International regulations MSS ITU IMT 2000 EU GSM 1800 UMTS DECT MDS US PCS Jp/Ko IMT 2000 China GSM 1800 IMT 2000

  12. Frequency division • By modulating a carrier frequency, the radiated power can be limited to a specified frequency range. • The width of the range is the bandwidth of the carrier. • A guard band is needed to protect adjacent carriers.

  13. Frequency planning A B C 3 cells per site typically used in urban environment

  14. Frequency planning 4 sites, 3 cells per site minimum distance 12 carriers needed A D B E C F A J G H K I L

  15. Time division • Enabled by faster processors. • A carrier is divided into time slots. • Each channel is allocated a time slot. • A guard period is needed between adjacent time slots

  16. Timing advance A sender must adjust its transmission to meet thetime slot at the receiver. The farther away the earlier you send . The base station will tell you if your late or early. a b B A

  17. Locating a mobile terminal 500 m

  18. What is left ? • when bandwidth is fixed • and power is limited • do the best modulation possible

  19. Modulation • frequency modulation • amplitude modulation • phase modulation • combination of above • … no modulation ?

  20. Wireless systems • Often use a phase modulation • Could change modulation depending on quality of signal • Spectral efficiency • up to 2 bits raw data per Hz under good conditions • aprx 0,5 to 1 bit user data per Hz • limited by signal to noise ratio

  21. How do we compare? • What is the maximum user capacity? • What is the maximum capacity of a system? • How many carriers do we have? • What is the total capacity of a carrier? • How many carriers can be used at any given point?

  22. GSM • Each duplex carrier is 2x200 KHz wide • 900 • up 890-915 MHz down 935-960 MHz • 124 duplex carriers • 2x25MHz in total • 1800 • up 1710-1785 MHz down 1805-1880 MHz • 374 duplex carriers • 2x75MHz in total !!!!! • 1900 (in the US) • up 1850-1910 MHz down 1930-1990 • 2x60MHz in total

  23. GSM • Time division • 8 time slots per carrier • one carrier up one carrier down • Gaussian Minimum Shift Keying (GMSK) • user bitrate 9,6 kb/s or 14,4 kb/s per timeslot • raw bitrate 272 kb/s per carrier • HSCSD • Two or more time slots

  24. Up and down 0 1 2 3 4 5 6 7 down up The up link is delayed 3 slots in order togive the terminal time to adjust to the new frequency. Time slots 5 and 6 can be used to listen for better frequencies.

  25. GPRS • Dynamically allocate time slots • normally 1:4 one up, four down • Data and voice can be combined • Coding schemes (user data rates) • CS 1: 9,05 kb/s total 72,4 kb/s • CS 2: 13,4 kb/s total 107,2 kb/s • CS 3: 15,6 kb/s total 124,8 kb/s • CS 4: 21,4 kb/s total 171,2 kb/s

  26. EDGE • Enhanced data rate for GSM Evolution • Change the modulation to 8-PSK i.e. 3 bits per symbol • User data rate • 22,8 kb/s to 69,2 kb/s • Total of 553 kb/s • don’t move

  27. UMTS/WCDMA • Each paired carrier is 2x5MHz • 1900-1980, 2010-2025, 2110-2170 MHz • 155 MHz in total • Unpaired carriers can be used using time-division duplex mode (TDD) • A typical operator • Two or three paired, one unpaired • Up to six operators share the spectrum

  28. ISM 2.4 GHz • Industrial, Scientific and Medical • US 2400 – 24835 83,5MHz in total • Japan 2400 – 2497 89,7MHz in total • Open for anyone, no license • Limitation on power < 0.1W (<1W US) • Using a spread spectrum technique

  29. Spread spectrum • Why spread the signal over a wider spectrum? • more robust, will survive if part of the spectrum is noisy • will allow other systems to operate in the same environment • Two techniques • frequency hopping • direct sequence

  30. Frequency Hopping • divide the spectrum into separate carriers • In ISM, FCC regulated at least 70 carriers • transmit and hop • In ISM, FCC regulates < 400 ms • a code determines where to hop • how do we synchronize? • low cost, low power, very robust

  31. Direct Sequence • Increase the bandwidth by sending a pattern, chipping sequence, at a higher bitrate • sequence can be static or dynamic • dynamic patterns are used in CDMA • high bitrate, robust

  32. Bluetooth 1.1 • Frequency hopping, GFSK modulation • Gaussian Frequency Shift Key • 79 carriers of 1 MHz, 1600 hops per s • Power • Class 1: 20dBm (100mW) range aprx 100m • Class 2: 4dBm (2,5 mW) range aprx 10m • Class 3: 0dbM (1 mW) range aprx 10 cm • Master & Slave • Master determines hopping sequence • Capacity 712 Kb/s per channel

  33. 802.11b • DSSS, BPSK (1Mbps) QPSK (11Mbps) • ISM 2.4 • US 11 carriers • Europe (except France and Spain) 13 carriers • Japan 14 carriers • Carrier • 22 MHz wide • can use 3 carriers without overlap!

  34. 802.11b • 1 Mb/s using BPSK • Barker spread sequence of 11 bits • 2 Mb/s using QPSK • Barker sequence of 11 bits (22 Mb/s raw data) • 5,5 and 11 Mb/s • QPSK, same as for 2Mb/s • complementary code keying • 1,375M symbols/s • each symbol is 8 bits long (11 Mb/s raw data) • each symbol represents 4 or 8 bits

  35. 802.11b 11 Mb/s 8 b/symbol 8 chips/symbol 1,375 Msymb/s QPSK 5,5 Mb/s 4 b/symbol 8 chips/symbol 1,375 Msymb/s QPSK 2 Mb/s 1 b/symbol 11 chips/symbol 2 Msymb/s QPSK 1 Mb/s 1 b/symbol 11 chips/symbol 1 Msymb/s BPSK

  36. Code division • Same frequency can be used • No cell planning • How do we decode the message?

  37. Code division: coding 1 d1 d2 message di -1 1 code cik -1 1 Zik= dik * cik out zik -1

  38. Code division: decoding 1 out zik -1 1 code cik -1 S m 1 di = zikcik m k = 1 1 d1 = (-1 –1 – 1 –1 – 1 – 1 –1 – 1) = -1 8

  39. Code division: multiple senders Da = -1-1-1-1-1-1-1-1+1+1+1+1+1+1+1+1 Ca = +1+1+1-1+1-1-1-1+1+1+1-1+1-1-1-1 Za = -1-1-1+1-1+1+1+1+1+1+1-1+1-1-1-1 Db = +1+1+1+1+1+1+1+1+1+1+1+1+1+1+1+1 Cb = +1-1+1+1+1-1+1+1+1-1+1+1+1-1+1+1 Zb = +1-1+1+1+1-1+1+1+1-1+1+1+1-1+1+1

  40. Code division Za = -1-1-1+1-1+1+1+1+1+1+1-1+1-1-1-1 Zb = +1-1+1+1+1-1+1+1+1-1+1+1+1-1+1+1 Zab= +0-2+0+2+0+0+2+2+2+0+2+0+2-2+0+0 Zab= +0-2+0+2+0+0+2+2+2+0+2+0+2-2+0+0 Ca = +1+1+1-1+1-1-1-1+1+1+1-1+1-1-1-1 ZCa= +0-2+0-2+0+0-2-2+2+0+2+0+1+2+0+0 Sa= -8/8 = -1 +8/8 = +1

  41. Ultra wide band More than 1.5 GHz or 20% of central frequency Use low power, low enough to disappear in noise level of other systems Compensate by using large bandwidth, up to several GHz Distance is, due to low power, limited < 10 m UWB

  42. Shannon revisited • Shannon’s theorem sets a limit for one receiver listening to one message. • What happens if we have several channels open, multiple receivers. • Is there a limitation on capacity in space?

  43. WCDMA • 5 MHz carrier • QPSK modulation • 3,84 Mcps chipping rate

More Related