1 / 31

Analog Communications

Analog Communications. Dr. M. Venu Gopala Rao A.M.I.E.T.E , M.Tech, Ph.D ( Engg ) Cert. in R.S.T ( City & Guild’s London Institute , London ) F.I.E.T.E, L.M.I.S.T.E, I.S.O.I. , S.S.I. , M.I.A.E . Professor, Dept. of ECE , K L University mvgr03@kluniversity.in. FM Generation.

jdilworth
Télécharger la présentation

Analog Communications

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Analog Communications Dr. M. Venu Gopala Rao A.M.I.E.T.E,M.Tech, Ph.D(Engg) Cert. in R.S.T (City & Guild’s London Institute, London) F.I.E.T.E,L.M.I.S.T.E, I.S.O.I., S.S.I., M.I.A.E. Professor,Dept. of ECE, K L University mvgr03@kluniversity.in

  2. FMGeneration

  3. Indirect FMGenerationArmstrongMethod

  4. Indirect FM (Armstrong)Generation Step1Generation ofNBFM

  5. Step2:Frequency Multiplication MemorylessNon-linear operation Band Pass Filter (BPF): WBFM Generation

  6. Example Design an WBFM transmitter to transmit audio signals containing frequencies in the range 100 Hz to 15 kHz. The NBFM is supplied with a carrier wave of frequency f1 = 0.1 MHz by a crystal controlled oscillator. The desired FM wave at the transmitter output has a carrier frequency of fC = 100 MHz and frequency deviation 75 kHz.

  7. Example Let Then To produce Frequency Multiplication Two stages

  8. Two stages

  9. Direct FMGeneration /ParameterVariationMethod

  10. 1. FM ReactanceModulators

  11. The gate voltage Then the drain current Impedance Assuming that the impedance

  12. When the modulating signal is applied, the gate to source voltage varied accordingly, causing proportional change in gm . As a result the frequency of oscillator tank circuit is a function of the amplitude of the modulating signal and the rate at which it changes is equal to fm .

  13. 2. Varactor DiodeModulator The capacitance of a varactor diode is inversely proportional to the reversed biased voltage amplitude. where Form(t) , the capacitance where

  14. Frequency stabilized FM modulator The carrier frequency is not obtained from a highly stable oscillator.

  15. Limitations of direct methods of FM generation • Difficult to obtain a high order of stability in carrier frequency because tank circuit consists of L and C. The crystal oscillator can be used for carrier frequency stability, but frequency deviation is limited. • The non linearity produces a frequency variation due to harmonics of the modulating signal hence there are distortions in the output FM signal.

  16. FM Demodulators

  17. BasicIdea where = demodulated output signal (Volts) = demodulator transfer function (Volts per Hertz) = difference between the input frequency and the center frequency of the demodulator (Hertz).

  18. 1. SlopeDetector

  19. SlopeDetector . . . Advantages:The only advantage of the basic slope detector circuit is its simplicity. Limitations: (i) The range of linear slope of tuned circuit is quite small. (ii) The detector also responds to spurious amplitude variations of the input FM. These drawbacks are overcome by using balanced slope detector.

  20. Balanced SlopeDetector

  21. Balanced SlopeDetector

  22. Balanced SlopeDetector Advantages: (i)This circuit is more efficient than simple slope detector. (ii) It has better linearity than the simple slope detector. Limitations: (i)Even though linearity is good, it is not good enough. (ii) This circuit is difficult to tune since the three tuned circuits are to be tuned at different frequencies, and (iii) Amplitude limiting is not provided.

  23. Foster-Seeley Discriminator (Phase Discriminator)

  24. Foster-Seeley Discriminator

  25. Foster-Seeley… Advantages: • Tuning procedure is simpler than balanced slope detector, because it contains only two tuned circuits and both are tuned to the same frequency . • Better linearity, because the operation of the circuit is dependent more on the primary to secondary phase relationship which is very much linear. Limitations: It does not provide amplitude limiting. So in the presence of noise or any other spurious amplitude variations, the demodulator output respond to them and produce errors.

  26. Ratio Detector Similar to the Foster-Seeley discriminator . (i) The direction of diode is reversed. (ii) A large capacitance Cs is included in the circuit. (iii) The output is taken different locations. Advantages: • Easy to align. • Good linearity due to linear phase relationship between primary and secondary. • Amplitude limiting is provided inherently. Hence additional limiter is not required.

  27. Ratio Detector

  28. Performance Comparison of FM Demodulators

  29. Main Points of Angle Modulation • An angle-modulation signal is a nonlinear function of the modulation, and consequently, the bandwidth of the signal increases as the modulation index increases. • The discrete carrier level changes, depending on the modulating signal, and is zero for certain types of modulating waveforms. • The bandwidth of a narrowband angle-modulated signal is twice the modulating signal bandwidth (the same as that for AM signaling). • The real envelope of an angle-modulated signal is constant and consequently does not depend on the level of the modulating signal.

  30. End

More Related