1 / 29

Asphalt Rubber Seal Coats

Asphalt Rubber Seal Coats. How many cracks can you fill in one day?. Is there a better way to take care of these cracks?. A seal coat alone will not do the job with monster cracks!. Asphalt Rubber Blend Site. Distressed Surface. Asphalt Rubber Binder Application.

jennis
Télécharger la présentation

Asphalt Rubber Seal Coats

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Asphalt Rubber Seal Coats

  2. How many cracks can you fill in one day?

  3. Is there a better way to take care of these cracks?

  4. A seal coat alone will not do the job with monster cracks!

  5. Asphalt Rubber Blend Site

  6. Distressed Surface

  7. Asphalt Rubber Binder Application

  8. Pre-Coated Aggregate Application

  9. Longitudinal Joint Overlap

  10. Rolling

  11. Sweeping Loose Aggregate

  12. Finished Surface

  13. Fog Seal Application

  14. Comparison

  15. The difference AR Seal Coat makes

  16. A good candidate for AR Seal Coat: Lots of cracks, but structurally sound.

  17. Texas Experience with AR Seal Coat • Firstuse was in 1976 in Bryan and El Paso districts • Between 1976 and 1981, 850 miles of AR seal coat was placed • By 1990, 2,000 lane miles of AR Seal Coat was placed • More than 20 districts have placed AR Seal Coat since 1976 in 70 counties

  18. Seal Coat - US 90, near Big Bend National Park

  19. US 90, crack disappearing in 10 year old Seal Coat

  20. Eight year old Seal Coat

  21. Seal Coat on IH-10 near Van Horn Five years old

  22. Seal Coat on IH-10 near Van Horn Five years old

  23. Not all AR Seal Coats Turned out good Grade 4 Seal Coat

  24. Another bleeding Seal Coat

  25. Smaller grade 4 Aggregate will sink into the AR Binder

  26. Performance of AR Seal Coat • Experience has mostly been satisfactory • Good construction practices are a must! - Clean or pre-coated aggregate - Chip spreader staying close to distributor - Adequate curing of AR - Correct binder shot rate and aggregate rate

  27. Performance of AR Seal Coat • Shot rate must correspond to aggregate top size: - Grade 3 vs.. Grade 4 aggregate - Earlier problems with flushing were most likely due to aggregate size

More Related