1 / 15

Outage-Optimal Relaying In the Low SNR Regime

Outage-Optimal Relaying In the Low SNR Regime. Salman Avestimehr and David Tse University of California, Berkeley. Diversity. Unreliability of fading channels - Diversity gain. Transmit Diversity - Creates more diversity Diversity gain=2.

matia
Télécharger la présentation

Outage-Optimal Relaying In the Low SNR Regime

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Outage-Optimal RelayingIn the Low SNR Regime Salman Avestimehr and David Tse University of California, Berkeley

  2. Diversity • Unreliability of fading channels • - Diversity gain • Transmit Diversity • - Creates more diversity • Diversity gain=2 • Transmit diversity: may not be practical • - most handsets (size) • - wireless sensor network (size, power)

  3. S2 R D S1 S D Relay Symmetrical Cooperative communication • Single-antenna mobiles share their antennas • - Virtual Multiple-Antenna system • Two scenarios:

  4. Outline • Explaining the Relay Scenario • Motivations • Upper bound on the outage capacity • Different protocols: Decode-Forward Amplify-Forward Bursty Amplify-Forward • Further Directions

  5. The Relay Scenario R g h2 D S h1 • Rayleigh fading channels + AWGN noise • Slow fading • Half-Duplex constraint • Channel State Information available at the receiver only • Average power constraint (P) on both S and R

  6. The Relay Scenario (cont.) • The problem is hard: Look at different regimes • Two Regimes of interest: high SNR, low SNR • High SNR (Laneman et. al. & Azarian et. al.): Diversity-Multiplexing tradeoff • Low SNR - CDMA - Sensor Networks

  7. Why Low SNR S D h • The capacity loss from fading is more significant at low SNR The impact of diversity (e=0.01) The impact of fading • The impact of diversity on capacity is more significant at low SNR

  8. Outage Capacity S D h • nats/s (fixed h) • Outage event at rate R: • For outage probability, e: • Outage Capacity: • For MISO channel: • For example at =0.01:

  9. Upper Bound on the Performance? R R • Min-cut max-flow bound: • The corresponding bound on the outage capacity, P g g h2 h2 bP D D S S h1 h1 (1-b)P

  10. Different Protocols • Decode-Forward: • First Time-slot: Source transmits the vector of encoded data. • Second time-slot: If relay was able to decode data, it will re-encode it and transmit it. • Not optimal, why? cut set: :Exploits Diversity MFMC upper bound Decode-Forward

  11. Amplify-Forward • First Time-slot: Source transmits the vector of encoded data, x. • Second time-slot: Relay retransmits the received vector by amplifying. No Diversity ! Why? MFMC upper bound Decode-Forward Amplify-Forward

  12. A Better Protocol ? • Bursty Amplify-Forward: - To have less noisy observation at the Relay, source transmits rarely (a fraction of the time) but with high power: be large - In order to be power efficient, we should pick a such that the effective rate is small: be small - Can we pick such a ? Yes, because at low outage probability is small. - The achievable rate of this scheme: - Why optimal?

  13. Summary of results MFMC upper bound Decode-Forward Amplify-Forward Bursty Amplify-Forward Outage Capacity

  14. Further directions • Full CSI (both Rx and Tx know the channel): • Allocate some power for beam forming • Can also be achieved by BAF + beam forming R P g h2 bP D S h1 (1-b)P

  15. The gain from Full CSI • With full CSI: the gain is small. • The reason is that in the previous optimization, only small amount of power will be allocated for beam-forming (6%). • In MISO the gain is 3dB, as all the power is used for beam-forming.

More Related