1 / 26

A New Numerical Design Method for Log-periodic Eleven Feed – The Partial Array Method

A New Numerical Design Method for Log-periodic Eleven Feed – The Partial Array Method. Jian Yang, Associate Professor Chalmers University of Technology Sweden. Outline. Introduction New Method: the partial array method Optimization Procedure Result of Optimization

mikko
Télécharger la présentation

A New Numerical Design Method for Log-periodic Eleven Feed – The Partial Array Method

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. A New Numerical Design Method for Log-periodic Eleven Feed – The Partial Array Method JianYang, Associate Professor Chalmers University of Technology Sweden

  2. Outline • Introduction • New Method: the partial array method • Optimization Procedure • Result of Optimization • Simulations and Measurements • Conclusions

  3. Introduction - The Eleven Feed dipoles • Two unique characteristics over decade bandwidth • Constant beam width; • Fixed phase center location Phase center Ground plane

  4. Introduction - The Eleven Feed • Simple geometry, small volume • Can be located in cryostat; • -10 dB reflection coefficient • Low cross pol. level

  5. Introduction - challenge • Minimizing reflection coefficient is needed. • Challenge: Eleven feed is very large at highest frequency. • New method for global optimization scheme. Photo of the 2-13 GHz Eleven feed

  6. New Method - Partial array method Scaled S-parameters due to scaled geometry • If the log-periodic array is infinite, we have the frequency scaling on s-parameters as: jdipole+n idipole+n jdipole idipole

  7. D6 D5 D4 D3 D2 D1 2 1 2 1 2 1 2 1 1 2 1 1 2 2 Partial Array Method: Scaled S-parameters • example:

  8. D6 D5 D4 D3 D2 D1 2 1 2 1 2 1 2 1 1 2 1 1 2 2 Partial Array Method: far separated mutual couplings very low

  9. Partial Array Method • We can predict the S matrix for the whole array using S parameters in a small part of the array by • Scaling S parameters; • Ignoring mutual coupling between far separated elements.

  10. Partial Array MethodImplementation Port definition port1 port2 S1(3)2(4) dipole4 dipole3

  11. Partial Array Method 0 S= 0

  12. Partial Array Method • Formula

  13. Partial Array Methodfor details J. Yang and P.-S. Kildal, “Optimizing large log-periodic array by computing a small part of it”, appears in IEEE Trans. on Antennas Propag. Special Issue on Antennas for Next Generation Radio Telescopes, vol. 59, no. 3, March 2011.

  14. Example Reflection coefficient of a 14-element log-periodic Eleven antenna array based on simulation of a 6-element array

  15. Optimization ProcedureGenetic Algorithm • Six parameters are optimized: • scaling factor k, • dipole length L, • arm width w, • arm spacing da, • transmission line gap dc, • height above ground plane h.

  16. Optimization • GA is used for minimizing S11 in a 6-element folded dipole array. • Elite crossover, Roulette wheel selection, crossover and mutation are used in GA. • population size: 50; • 5 generations; • Simulation tool is CST MS and the optimization is done by in-house Matlab program. • Computation Time • Each case 1 hours; • Fully optimized 1 week.

  17. Result of Optimization • 14 pairs of folded dipoles with scaling factor 1 .24.

  18. Result of Optimization • The port impedance is 200 Ohms.

  19. Simulated and Measured ResultsReflection coefficient including centre puck

  20. φ : 0-360o with step 1o. θ : 0-180o with step 1o. Frequency: 2–15 GHz with step 0.1 GHz. Spherical near field measurement Radiation Measurement at Technical University of Denmark

  21. Efficiencies based on measured patterns in reflector with subtended semi-angle of 60 deg

  22. Efficiencies based on Simulated patterns in reflector with subtended semi-angle of 60 deg

  23. Radiation Patterns of BOR1 component Simulated Measured

  24. Directivity

  25. Conclusions • The reflection coefficient is below -10 dB for 2 – 13 GHz. • The radiation pattern is constant for 2 – 13 GHz. • BOR1 efficiency is • > -0.5 dB for most part of 2 – 13 GHz, • > -1.5 for 2 –13 GHz. • Directivity is about 11 dBi. • Aperture efficiency is better than – 3 dB for 2 – 13 GHz.

  26. Questions?

More Related