Servo Voltage Stabilizer – Manufacturer of electrical equipments: Power Engineers Company

1. Servo Voltage Stabilizer - Manufacturers, Suppliers, Exporters of electrical equipments: Power Engineers Company Power Engineers Co is Manufacturer, Exporter & Supplier of electrical equipment from Gujarat likeServo Voltage Stabilizer, Ultra Isolation Transformer, Dry Type Transformer, Servo Voltage Stabilizers, Variable Voltage Regulator, Electro plating Rectifiers. Power Engineers Company have developed and installed industrial voltage stabilizer throughout India which are suitable for 100% continuous duty cycle supplied up to 5000 KVA which have more than 99. 5% efficiency. Benefits of Servo Voltage Stabilizer: Reduction in breakdown of electrical equipments up to 60-80%. Energy saving: 5 to 10% on motor load & 15-25% on lighting load. Reduction in MDI: Definite reduction in MDI by 10-15%. Improvement in power factor: In case of high voltage only. Depreciation allowance @ 80% as per Income tax Act Uniform quality of end product. www.pecindia.co.in/products/servo-voltage-stabilizers

2. Voltage Optimisation is a term given to the systematic controlled reduction in the voltages received by an energy consumer to reduce energy use, power demand and reactive power demand. Over Voltage Various technologies can be used to avoid overvoltage, but it must be done so efficiently so that energy savings resulting from using the correct voltage are not offset by energy wasted within the device used to do so. Reliability is also important, and there are potential problems inherent in running full incoming power through electro-mechanical devices such as automatic voltage controller. Under Voltage refers to voltage lower than the voltage at which equipment is designed to operate most effectively. If the design of the VO does not take into consideration voltage drop over distance to remote power users, then this may lead to premature equipment failure, failure to start up, increased temperature in the case of motor windings and loss of service. Effects on Electrical Loads: A common misconception as far as Voltage Optimisation is concerned is to assume that a reduction in voltage will result in an increase in current and therefore constant power. The benefit to typical equipment at three phase sites is discussed below. Energy Savings: The energy savings achieved by Voltage Optimisation are an aggregation of the improved efficiency of all equipment across a site in response to the improvements in the power quality problems outlined above. It has been and continues to be a key technique for savings in energy consumption. For more details visit:http://www.pecindia.co.in/products/servo-voltage-stabilizers/ www.pecindia.co.in/products/servo-voltage-stabilizers