90 likes | 388 Vues
E N D
1. 1600 SeriesOperation (See Installation and Operation Manual for detailed instructions)
2. 2 FoamPro 1600 Series Fully automatic
Class A foam ONLY
Proportions between 0.1% to 1%
Flowmeter standard
(1", 1-1/2" or 2" tee)
Operators control panel
3. 3 Electronic DirectInjection Proportioner
4. 4 Controller includes:
Operating instructions
On/Off switch
Injection rate control
Adjustable from 0.1%-1.0%
System Status Light Features And Operations
5. 5 System Status Light Codes:
Light flashes then goes out
System ready to operate
One flash per second
Simulated flow mode engaged
Remove power; disengaged automatically
Solid light
No concentrate
Two flashes per second
Concentrate level low
5 flashes per second
Electrical error
Features And Operations (cont.)
6. 6
Features and Operations (cont.)
7. 7 Enter “SIMULATED FLOW”
Valve to “CAL/FLUSH”
Turn panel switch “ON”
Run pump until concentrate flows from dump line Purging Air
8. 8 Purging Air (cont.)
9. 9 Foam concentrate strainer
Clean out regularly
If little or no foam concentrate is injected while system is running, check for clogged strainer
Purge air from foam pump afterwards Maintenance