1 / 6

Suggested Changes to Heat Pump Installation Checkout Procedure

This document outlines suggested changes to the heat pump installation checkout procedure, focusing on eliminating third-party charges, enhancing evaluation methods, and ensuring system performance to meet manufacturer's specifications.

susane
Télécharger la présentation

Suggested Changes to Heat Pump Installation Checkout Procedure

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Suggested Changes to Heat Pump Installation Checkout Procedure Baylon, Davis, Strand Ecotope, Inc. 7 June 2005 RTF Meeting Portland, OR

  2. Installation Check Out –Suggested Changes • Eliminate third party charge evaluation requirement (Section 5.4 of PTCS specs) • Field study suggests limited problem • EWEB analysis suggests impact only in extreme cases (exact conditions unknown) • Lab tests show no significant impact until system significantly undercharged • Contractors have resisted this step or tried to short-circuit it

  3. Suggested Changes (2) • Require an indirect evaluation that also addresses homeowner comfort (and do it in heating mode) • Measure airflow (TrueFlow preferred) – already required in Section 6.4 of RTF and PTCS specs • Measure sensible split at plenums after 15 minutes of heating operation • Calculate output and compare with mfr’s target • Require documentation of line set length and adjustments made to charge level (already mentioned in both RTF/PTCS specs) • Require documentation of operating pressures and ambient conditions

  4. Capacity Measurement Capacity is known from temp split and airflow and can be compared with mfr’s info • Customer/utility have recourse • Installer has data to submit to mfr if system is installed to spec and is not providing expected output

  5. Additional On Site Inspection Steps • Checklist of components (already detailed in specs) must be completed* • Accumulator (if required) • Crankcase heater (if required) • Filter dryer • Condensate pan(s)/pump • Indoor/outdoor thermostat operation must be confirmed and explained to homeowner • Timing of inspection important *could be by non-service tech with some training

  6. Additional Considerations • ECM blower flow needs to be measured (some board settings produce marginal flow) • Cooling season evaluation of charge can be done as before • Alternate means of calculating airflow (DB matching, temperature split) are acceptable as long as they are documented

More Related