Soldering Iron - AdvanceTech

1. Soldering Iron - AdvanceTech You may find the people also use the tool for the electronic repair and the joints which have the low power rating. It is better for you to do the proper melting process. You also need to maintain the solder carefully. If you do the improper technique in doing both of them, you may face the difficulty to stick the Soldering Iron or to the joint where you will attach it. However, if you find the problem, you may solve it by yourself since the difficulty level is quite easy. To do this, you have to prepare the tools like the Soldering Iron, the solder, the sponge, and water. The first thing you should do is to heat the tool. Turn on the iron's power by plugging the tool. Wait for a few minutes. It is better if it reaches 400 Celsius degrees. If your iron has the preheated function, you should wait for the tool to indicate it. You should wet the small sponge with the cold water and put it close to the preheating tool. You can check whether the iron is preheated or not by touching the tip to the Soldering Iron. If the solder is already preheated, the solder will melt. When you buy the soldering iron, you will receive the main power unit, the pencil, the pencil stand and a sponge attached to the pencil stand that you can use to clean the tip of the soldering iron.

2. All of those tools combined into the soldering station setup, provide you everything that you need to start your soldering project. After that, you need to clean the tool's tip with the sponge. You will need to roll the iron's tip to the soldier's piece. This step has the purpose to cover the iron with the solder. This process is called tinning. If you do it properly, your Soldering Iron will be able to flow to the joint. Contact US Address: 709-710, GD-ITL Towers, B-8, Netaji Subhash Place, Pitampura, New Delhi, India Email: ajay@advinancetech.co.in Phone: 9599592692 Website: http://www.advancetech.co.in