1 / 8

A New D C Measuring Method o f t he Thermal Resistance o f Power M OS Transistors

A New D C Measuring Method o f t he Thermal Resistance o f Power M OS Transistors. Krzysztof Górecki and Janusz Zarębski Department of Marine Electronics Gdynia Maritime University, POLAND. Outline. Introduction Description of the method Verification of the method Conclusions.

candid
Télécharger la présentation

A New D C Measuring Method o f t he Thermal Resistance o f Power M OS Transistors

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. A New DC Measuring Method of the Thermal Resistance of Power MOS Transistors Krzysztof Górecki and Janusz Zarębski Department of Marine Electronics Gdynia Maritime University, POLAND

  2. Outline • Introduction • Description of the method • Verification of the method • Conclusions

  3. Introduction • Thermal resistance describes ability of heat dissipation of semiconductor devices at the steady state • The thermal resistance Rth is expressed by • One can distinguish two kinds of methods of Rthmeasuring : • The optical (infrared) methods • The electrical methods • the advantage of the electrical methods is a possibility of estimation of the thermal resistance of both the capsulated and uncapsulated devices

  4. Introduction (cont.) • Two groups of electrical methods of Rth measuring are known: • The impulse methods • The dc methods • In both the methods the thermo-sensitive parameter is used • The advantage of dc methods is the lack of interferences connected with switching the investigated device and the simple measuring procedure • In the paper a new dc method of measuring the thermal resistance of power MOS transistors is proposed

  5. Description of the method (1) • The coordinates of four operating points of the investigated MOS transistor operating in the saturation region should be measured • A(uGS1, uDS1, iD), B(uGS2, uDS2, iD), C(uGS3, uDS3, iD1) and D(uGS4, uDS4, iD2) • The coordinates of the points A, B, C and D must meet the following conditions • Using these coordinates the values of the MOS transistor model parameters UP0,aU, k should be calculated,

  6. Description of the method (2) • Calculation of the Rth value using following formula where aGS is given by

  7. Verification of the method • The experimental verification of the new method was carried out for the power MOS transistor IRFR024N placed in the case D-PAK and operating without anyheat-sink • The coordinates of the measuring points: • From the new method Rth = 75 K/W • From the pirometric method Rth = 72 K/W

  8. Conclusions • In the paper the new method of measuring the value of the thermal resistance of power MOS transistors is proposed. • The realization of the method is simple and requires only to perform the measurements of the coordinates of the four operating points of the investigated transistor situated inside the saturation region and to carry out some calculations with the formulas given in the paper. • It was experimentally shown that the measuremental results obtained with the presented direct-current method are convergent with the results obtained with the pirometric method with the differences between them not exceeding a few percentage. • Another advantage of the use of the new method is measuring the value of the threshold voltage UPO of the investigated transistor, the temperature coefficient aU of changing of this voltage and the exponent k describing the dependence of the parameter transductance on temperature.

More Related