1 / 5

Load line analysis of BJT and its Stability

Descriptive Load line analysis of BJT and its Stability

chandrasatish1989
Télécharger la présentation

Load line analysis of BJT and its Stability

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Load line analysis of BJT and its Stability AC load line Presentation for the faculty position (ECE)

  2. (b) Transistor is driven in saturation because Q-point too close to saturation region (a) Transistor is acting as amplifier because Q-point is middle of saturation and cut off region (d) Transistor is driven into both saturation and cutoff because the input signal is too large (c) Transistor is driven in cut off region because Q-point too close to cut-off region Presentation for the faculty position (ECE)

  3. After selection of Q-point, it must be remained fixed to have amplified signal without clipping Some important equations (1) (2) where, (3) Here, , and are very responsive towards any temperature variation. So, We need to define arrangement to make Q-point fixed (i.e., biasing) and check it stability by stability factor (S) (4) From (2), (5) Presentation for the faculty position (ECE)

  4. Fixed bias circuit Collector to base biasing Potential divider biasing ⇒ Therefore, or ⇒ Therefore, ⇒ Therefore, Presentation for the faculty position (ECE)

  5. The best Q-point for the operation of a transistor as an amplifier is that point,  which lies in the middle of the load line. • The purpose of biasing is to establish the operating point(Q-point). • Potential divider biasing is best biasing circuit amongst all three biasing. • independent of β Presentation for the faculty position (ECE)

More Related