1 / 8

DNB Attenuation or “Misuse” of MSE Data continued…

MIT Plasma Science and Fusion Center. DNB Attenuation or “Misuse” of MSE Data continued…. Rachael McDermott, Bill Rowan Thanks to Steve Scott and Howard Yuh for numerous consultations. What and Why?. Using MSE data to find accurate estimates of neutral beam attenuation

ronli
Télécharger la présentation

DNB Attenuation or “Misuse” of MSE Data continued…

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. MIT Plasma Science and Fusion Center DNB Attenuationor“Misuse” of MSE Datacontinued… Rachael McDermott, Bill Rowan Thanks to Steve Scott and Howard Yuh for numerous consultations

  2. What and Why? • Using MSE data to find accurate estimates of neutral beam attenuation • These measurements can be used to benchmark beam penetration codes currently in use. • Accurate knowledge of neutral density is necessary for calculations of impurity densities in the plasma.

  3. Last time we… • Found a set of channel-to-channel calibration factors for the MSE diagnostic • Used these factors to derive relative beam attenuations from the MSE signal for beam into plasma shots To Do List from last time • Understand the calibration at all pressures. • Compare the attenuations to standard results from the literature and from our own penetration code

  4. Calibration Constants • Due to a calculation error, the calibration constants presented at the last presentation were incorrect. The correct (hopefully) constants are shown above. • We still don’t have an explanation for the discrepancies between the pressures. The lowest pressure constants are used for the beam density calculation.

  5. Comparison to Literature • An analytical fit to the stopping cross-section for a neutral beam into a hydrogen plasma as derived by Janev is • A theoretical beam attenuation can be derived from this as follows Janev, R.K., Boley, C.D., Post, D.E. (1989) PENETRATION OF ENERGETIC NEUTRAL BEAMS INTO FUSION PLASMAS. NUCLEAR FUSION, Vol. 29, No.12, 2125-2139

  6. Decay Constants • All of the attenuation curves were fit to The values of the parameters for two shots are given in the table below. • As the level of impurities is increased in the predicted model so does its agreement with the MSE attenuation.

  7. Prediction and Experiment The predicted beam attenuation for each shot is calculated using the CMOD temperature, and density profiles. The temperature profile was obtained from ECE. The density profile was obtained from the Visible Bremsstrahlung diagnostic. • An MSE derived beam attenuation along with its corresponding Janev-predicted beam attenuation is pictured above. This is for shot = 1040505029.

  8. Conclusions • An astonishing 39 of 41 shots fit well to exponential curves and were consistent with predicted results. To Do List • Explain calibration constant variation with pressure. Find another way to derive a channel-to-channel MSE calibration. • Include an error analysis in the derivation of the densities. • Include a measure of the difference between the calculated and predicted attenuations. • Finish writing this program in a “user friendly” form that can be run after each shot.

More Related