150 likes | 248 Vues
MEG positron spectrometer. Oleg Kiselev, PSI on behalf of MEG collaboration. Motivations of the experiment. + → e + decay is a forbidden process in the Standard Model (SM) – conservation of lepton numbers In case of massive neutrinos and mixing – allowed on negligible level
E N D
MEG positron spectrometer Oleg Kiselev, PSI on behalf of MEG collaboration
Motivations of the experiment • +→ e+ decay is a forbidden process in the Standard Model (SM) – conservation of lepton numbers • In case of massive neutrinos and mixing – allowed on negligible level • In all SM extensions the branching ratio is enhanced, predictions are 10-12 – 10-14 (Y. Kuno, Y. Okada, Rev. Mod. Phys. 73 (2001) 151) • Relatively simple process - e+ and should be emitted in the opposite directions with the same energy of 52.8 MeV • The main goal of the experiment is to reach a sensitivity of 10-13 - two orders of magnitude lower than current limit
Signal and background Signal Background e+ + e+ + + → e+ e+e+ → • = 180 E = Ee = 52.8 MeV T = Te + → e+ e+ + e Key features – intense DC muon beam; precise gamma energy measurement; precise positron energy measurement; precise time measurement
MEG setup 108 muons/sec Thin CH2 target Liquid Xenon calorimeter (10% acceptance, 800 l, 846 PMTs, t 60 ps, E 1%, high light yield) Scintillation Timing Counter (t 50 ps) COnstant Bending RAdius spectrometer inside superconducting magnet (B = 1.27 T at Z = 0 and decreasing as Z increases, B = 0.49 T at Z =1.25 m) Ultra low positron detection system
COBRA magnet Highly gradient field, 5 superconducting + 2 warm (compensation coils)
Spectrometer - requirements • Very high counting rate – up to 108 stopped muons • Good momentum (0.4%) position ( 300 m for r, z) & time resolution (50 ps) • Multiple scattering is a limiting factor & -background should be suppressed low mass system
Layout of DCs Low mass – the most hard requirement → He-filled spectrometer, He-based gas mixture, no strong frames Opened-frame structure!
anodereadout DC structure Two independent layers for resolving left-right ambiguity Drift field 4 kV/cm, drift velocity 4 cm/sec Resolution 1 cm via charge division 0.3 cm via ratio of signals from two strips
DCH waveforms Full information about charge and time is recorded
Gas regulation dP 1 Pa, P 0.1 Pa! Due to the 12 m foils and opened-frame structure a pressure regulation needs to be extremely precise
Timing counter Parameters: 2-layer structure – outer thick scintillation bars PMT readout for timing inner scintillation fibers APD readout for z-trigger Requirement of the experiment – 40 ps () One of the best results!
MEG electronics • Key feature - waveform digitizing of all signals best pile-up rejection possibility • Use of DRS2 and DRS3 FADC chips – 12 bit, 1.5 GHz for calorimeter, 500 MHz for DCHs • Customized trigger system – FPGA perform a fast energy, time and position reconstruction; set of trigger criteria is programmed • Slow control with a connection to the MIDAS DAQ logging of all important parameters DRS4 – improved design, up to 5 GHz! Very high demands for processing power Very high data rate
Status of experiment • All components of MEG setup are operational and tested during a commissioning run in December 2007 • Unique feathers of the positron spectrometer should allow to reach the goal of the experiment • Start of data taking – July 2008
Paul Scherrer Institute J. Egger, M. Hildenbrandt, P.-R. Kettle, O. Kiselev, S. Ritt, M. Schneebeli