1 / 10

BENCH BLOCK

BENCH BLOCK. TERMINOLOGY. F.I.M. - Full Indicator Movement RPM - Revolutions Per Minute A.I.S.I. - American Iron & Steel Institute 4140 - Last two digits represent % of carbon. EQUIPMENT. Building this bench block will give you experience using:. Lathe Vertical Mill Horizontal Mill.

trella
Télécharger la présentation

BENCH BLOCK

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. BENCH BLOCK

  2. TERMINOLOGY • F.I.M. - Full Indicator Movement • RPM - Revolutions Per Minute • A.I.S.I. - American Iron & Steel Institute • 4140 - Last two digits represent % of carbon

  3. EQUIPMENT Building this bench block will give you experience using: • Lathe • Vertical Mill • Horizontal Mill • Bandsaw • Heat Treat Oven • Surface Grinder

  4. DRAW THIS PART 1/4” 1.000 +- .005 .500 1/4”

  5. PROCEDURE - SAW • Cutoff 2-3/4” diameter x 1-1/4” long A.I.S.A. tool steel.

  6. PROCEDURE - LATHE • Chuck in lathe, in four jaw chuck • Indicate to within .015 F.I.M. • Face to cleanup surface at 80 RPM. • Turn OD to 2.450+- .005”. • Turn OD to 2.450+- .005 x1/4” from face.

  7. PROCEDURE - LATHE • Check if there is time to : • Center drill. • Drill 1/2” hole thru at 400 RPM. • Turn ID to 2.00+-.010” x3/8” deep at 100 RPM.

  8. PROCEDURE - LATHE • Remove turn part around rechuck on 1/4” shoulder and indicate to .002” F.I.M. • Face to 1.020+- .005 at 80 RPM. • Turn OD to 2.400+- .005 x 1/4”from face.

  9. HORIZONTAL MILL • Setup in vice on parallels, leave 3/8” minimum above vice . • Setup 90 cutter on arbor. • Position center of cutter in center of workpiece. • Touch rotating cutter to top of workpiece.

  10. HORIZONTAL MILL • Take two cuts, .125 deep each at 80 RPM. • remove 90 cutter, replace with 1/8” cutter. • Center cutter in center of grove. • Make one cut 1/8” deep.

More Related