1 / 8

Fabrication pH Electrode Using Lift-Off Method and Electrodeposition

Fabrication pH Electrode Using Lift-Off Method and Electrodeposition. Presented by Na Zhang. What ’ s the Problem?. How to create clear windows in the substrate?. How to solve the problem?. Lift-Off Method LOL-2000 (bottom) S -1813 Photoresist (top). Electrodeposition. pH Sensitivity.

Télécharger la présentation

Fabrication pH Electrode Using Lift-Off Method and Electrodeposition

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Fabrication pH Electrode Using Lift-Off Method and Electrodeposition Presented by Na Zhang

  2. What’s the Problem? • How to create clear windows in the substrate?

  3. How to solve the problem? • Lift-Off Method LOL-2000 (bottom) S -1813 Photoresist (top)

  4. Electrodeposition

  5. pH Sensitivity Electrode #1 03-12-04_630s_30s_ph678_1.bin

  6. Electrode #503-12-05_630s_30s_ph678_1.bin

  7. End

  8. Reference Procedure • 1) Clean substrate • 2) Spin spacer layer LOL-2000 @ 3000 rpm for 200nm thickness • 3) Bake 140 C on hot plate for 5 minutes • 4) Spin resist layer S-1813 @ 4000 rpm for 1.3 um thickness • 5) Bake 110 C on hot plate for 2 minutes • 6) Expose through pattern mask, 45s @ 2.45 mW/cm2 (110 mJ/cm^2 nominally)at UV250 mask aligner, intensity measured using the 400nm probe. • 15 s @ 10 mW/cm2 (150 mJ/cm^2 nominally) at UV400 mask aligner. • 7) Develop in MF319 for 30 sec, CAREFUL agitation • 8) Rinse in DI water • 9) Blow dry CAREFULLY. • 10) Ash at 50W 250mTorr Oxygen for 30 s • 11) Deposit thin film • 12) Lift off in NMP (Remover 1165)

More Related