1 / 77

AIRCRAFT ELECTRICAL SYSTEMS

AIRCRAFT ELECTRICAL SYSTEMS. Objectives. Students will be able to: Describe the basic components of aircraft electrical system Explain operation of electrical system Interpret aircraft electrical diagram Select proper size of wire for installation

yazid
Télécharger la présentation

AIRCRAFT ELECTRICAL SYSTEMS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. AIRCRAFT ELECTRICAL SYSTEMS

  2. Objectives Students will be able to: • Describe the basic components of aircraft electrical system • Explain operation of electrical system • Interpret aircraft electrical diagram • Select proper size of wire for installation • Describe basic causes of electrical system malfunctions

  3. Elements of aircraft electrical systems • An aircraft electrical system is mainly composed of : • Power sources • Components - Control devices - Conversion devices - Protection devices. • Power distribution systems • Electrical loads

  4. Electrical Power Sources Electricity power sources on an aircraft may be classified into two groups : • Batteries - Lead-acid - Nickel-cadmium • Generators - DC generators - AC generators

  5. Battery • A battery is a device that converts chemical energy into electrical energy. • It is a power reservoir that stores energy in chemical form.It does not produce energy. • Its functions are: - To provide power when no other power source is available - To assist in damping transient loads in the dc system

  6. - To provide a short term source during emergency condition • The capacity of battery is measured in ampere-hours. • Its normal rate is a little over 24vdc in a 28vdc system. • It is automatically recharged when the engine-driven generator is operational. • Two types of batteries are used in aircraft - Lead-acid batteries - Nickel cadmium batteries

  7. Lead-acid battery • It is usually found in piston aircraft. • It is made up of cells which have positive/negative plates of lead and filled with electrolyte of sulfuric acid and water. • Each cell has app. 2.2v, but is simply rated as 2 v. • It has corrosive effects. • Frequent total discharge and remaining battery in discharged condition for a long time will shorten the life of the battery.

  8. Battery Cell

  9. Nickel cadmium battery • They are the most common type of battery used in turboprop and turbojet aircraft. • They provide electrical discharge at a high rate without voltage drop and accept high charge rates that shorten recharge time • They may be subject to thermal runaway condition caused by overheating, in which the battery destructs itself.

  10. Nickel-cadmium battery Cell Terminals Vent pipe Container Main connector

  11. GENERATORS • A generator is a machine that converts mechanical energy into electrical energy by the process of electromagnetic induction • They are driven by the engine(s), and sometimes by APU. • A generator must be rated at adequate amperage to drive all the operating components on its circuit(s). The current required to operate each electrical component is known as its load.

  12. All generators produce alternating current naturally.The method which is used to take it from the coil will determine if the generator provides ac or dc to the circuit. • If a commutator is used for this purpose it will be a dc generator. • If a slip ring is used it will be an ac generator.

  13. DC GENERATORS: • Commutator in the generator converts the ac current to dc current. • DC generator is designed to supply nearly constant voltage. Usually the voltage is 28vdc, but there are 270vdc systems developed recently. • They supply current up to 400 A. • Most aircraft do not have a separate dc generator, but ac produced by ac generator is converted to dc to power dc systems.

  14. Basic dc generator

  15. Operation of a basic dc generator

  16. Producing steady dc

  17. AC generator (Alternator) • On most large aircraft high-load electrical devices are usually AC powered. • AC is produced by ac generator which is usually called alternator. • AC generators use slip rings instead of commutators to provide the current to the circuits. • Alternator generates three-phase current, and standard aircraft voltage is 115 vac with 400 Hz.

  18. Basic ac generator

  19. Modern electrical power generation types Mainly two types of electrical power generation currently in use on aircraft. - Constant frequency Integrated drive generators (IDG) - Variable speed constant frequency (VSCF) generators

  20. Constant Speed IDG • It is essential that the alternator output have a frequency of 400 Hz with a very small tolerance. Thus rotational speed of alternator must remain absolutely constant. • This is accomplished by using a Constant Speed Drive (CSD) unit between the engine and alternator. • CSD provides a constant alternator rpm within a specified engine rpm range.

  21. An alternator and constant speed drive unit combination is called integrated drive generator (IDG). • CSD is hydromechanically operated and needs to be correctly maintained in terms of oil level and oil cleanliness. • It is the most commonly used power generation method on today turbine-powered aircraft.

  22. Integrated Drive Generator

  23. Constant speed drive

  24. Constant Speed Drive

  25. VSCF • In this method, the variable frequency power produced by the alternator is converted to constant frequency 400 Hz, 115 vac by solid-state devices electronically. • Thus there is no need for CSD unit. • It is a new technique and limited in use.

  26. Variable speed constant frequency generator

  27. Power Generation Control • Power produced by generators is usually controlled by generator control unit (GCU). • The main functions of this device are: - Act as a voltage regulator - Direct current to battery for recharging - Provide circuit and generator protection by disconnecting the generator from the system when electrical abnormalities occur.

  28. Control Devices • These devices are use to initiate and control the operation of the circuits.Control devices include • Switches • Rheostats • Relays • Solenoids

  29. Switches • A switch is used to start, to stop, or to change the direction of the current flow in the circuit. • Toggle switches :They are on/off switches and extensively used in aircraft electrical system. • Push Switches : They are used primarily for operations of short durations • Rotary switches :When it is necessary to select several condition for a circuit, a rotary switch may be used.

  30. Rotary Switch

  31. Toggle switch

  32. Rheostats : control the amount of current that flows throughout the circuit and used as dimmer devices for instrument and cockpit lights. Relays :Electromagnetic switching devices which are used to remotely control electric circuits carrying large amount of current. Solenoids : Remote control devices quite similar to relays; but they are designed to move a shaft over a short distance. Thus, solenoids are used as mechanical control devices to operate hydraulic or pneumatic valves, locking pins, etc.

  33. Rheostat

  34. Schematic of a relay

  35. Relay

  36. Conversion Devices There are many occasions within an aircraft electrical system where it is required to convert power from one form to another. Typical examples of power conversion are : - Conversion from dc to ac power - Conversion from 115vac to 28 vdc - Conversion from one ac voltage level to another - Battery charging (from 115vac to 28vdc)

  37. Following devices are used for these purposes : • Transformers • Rectifiers • Transformer-rectifier units (TRUs) • Inverters • Transistors

  38. Transformers : Used to change ac voltage level. • Rectifiers : Used to convert ac into high-amperage, low-voltage dc. • TRUs: Combination of transformers and rectifiers and used as main unit to convert alternator output to dc in an aircraft • Inverters : convert 28 vdc power to 26 vac power particularly for flight instruments or 115 vac. • Transistors : Electronic devices that control electron flow and convert ac to dc.

  39. Transformer

  40. Analogy to TRU (ac adapter)

  41. TRUs

  42. Inverter

  43. Analogy to inverter (ups for computer)

  44. Protection Devices • These devices are used to protect circuits, cables and system components from damage due to failures. • Fuses • Circuit breakers • Diodes • GCUs

  45. Fuses : They are designed to protect the cables against the flow of short-circuit and excessive current. They break the circuit and stop the current flow when the current exceeds a predetermined value. • Circuit breakers :They have same function with the fuses.The difference from the fuse is that they are resettable, while a fuse must be replaced. • Diodes : They are the electronic equivalent to the check valves in hydraulic system. They allow electricity to flow in one way only.

  46. Circuit Breakers

  47. Circuit Breakers

  48. Primary Causes of Electrical Circuit Failures • Open circuit : It is a circuit that is not complete or continuous. This is an uncommanded interruption of electrical power tosome components or systems. When an open occurs the affected component stop to operate, but the other components still remain in operative condition.

  49. Common causes of open circuit

  50. Short Circuit It occurs when electricity is allowed to take a shortcut through or around a component or system. This is the most serious problem. It has two effects : - Affected components have no power and fail to operate - Since current will not flow through affected components, the other components will be subjected to higher level of current causing them to burn out.

More Related